Huawei FT2050 User Manual
  1. Manuals
  2. Brands
  3. Huawei Manuals
  4. Touch terminals
  5. FT2050
  6. User manual

Huawei FT2050 User Manual

Fixed wireless terminal
Hide thumbs
Table of Contents

Advertisement

Quick Links

HUAWEI FT2050
Fixed Wireless Terminal

USER GUIDE

Advertisement

Table of Contents
loading

Related Manuals for Huawei FT2050

Summary of Contents for Huawei FT2050

  • Page 1: User Guide

    HUAWEI FT2050 Fixed Wireless Terminal USER GUIDE...

  • Page 2: Trademarks And Permissions

    Huawei Technologies Co., Ltd reserves the right to change or modify any information or specifications contained in this manual without prior notice or obligation.

  • Page 3: Front View

    Introduction  Note: The figures in this document are provided only for your reference. The fixed wireless terminal (FWT) that you have purchased may differ from that shown. Front View 10 11 Ports Item Item Antenna port Telephone port 1 Direct current (DC) input port Telephone port 2 Data port...

  • Page 4: Rear View

    Item Battery indicator If the FWT sources its power only from the battery (the power adapter is not connected), the following indicators apply: Steady blue: The battery is full.   Steady red: The battery is at medium capacity.  Blinking red: The battery is low and must be charged.

  • Page 5: Installing The Battery

    Installing a UIM Card (Optional)  Note:  Contact your service provider to find out whether a UIM card is required.  Because a UIM card and its gold contact area are easily damaged by scratches or bends, install or remove the UIM card with care. Install the UIM card as shown in the following figure.

  • Page 6: Connecting To The Power Adapter

    Connecting to the Power Adapter Generally, the FWT sources its power from the line power supply using the power adapter. Caution: Use only the compatible charger delivered with this FWT model. Using chargers for other device models or provided by other manufacturers may invalidate the warranty or cause a dangerous malfunction.
  • Page 7  Use the cables provided by the manufacturer.  You can connect the FWT to a telephone and a computer at the same time, but you cannot use the voice and data services simultaneously. Connecting the FWT to a Telephone The FWT provides two telephone ports.

  • Page 8: Checking The Signal Strength

    Checking the Signal Strength Power the FWT on and wait until some signal strength indicators turn on or until you hear a dial tone.  If no signals are received, all the signal strength indicators remain off for more than 5 minutes and you can only hear the re-dial tone.

  • Page 9: General Functions

    General Functions Starting the FWT The FWT takes about 20 seconds to start. Then you can check the signal strength.  Note: If all the signal strength indicators remain off, the FWT may be faulty or the network may not cover the area where you are using the FWT. To solve this problem, contact your service provider.

  • Page 10: Advanced Functions

    Press the * key to save the volume level. If you hear the confirm tone "toot", you have successfully set the volume level. If you hear the dial tone again, the FWT has returned to the off-hook state, and you can proceed to configure other settings.

  • Page 11: Troubleshooting

     Note: For details about the network connection settings, contact your service provider. Fax Service (Optional)  Note:  The fax service requires network support. The success rate of sending or receiving faxes depends on network conditions.  Do not use other services when you are using the fax service. ...
  • Page 12 If the battery is installed, the problem may result from low battery power. Then charge the battery. The FWT is powered on and connected to the power adapter, but the power indicator remains off. Check that the power adapter's output voltage meets the FWT's voltage requirement. The FWT is powered on and the power indicator is in normal state, but all the signal strength indicators are off.

  • Page 13: Warnings And Precautions

    Check your computer. If there is a virtual drive, right-click it and choose Open. Find the ETS_setup.exe file and double-click it to start the modem driver installation. If the problem persists, contact your service provider. Warnings and Precautions This section contains important information pertaining to the operating instructions of your device.

  • Page 14: Safety Of Children

     On a stormy day with thunder, do not use your device, to prevent any danger caused by lightning.  When you are on a call, do not touch the antenna. Touching the antenna affects the call quality and results in increase in power consumption. As a result, the talk time and the standby time are reduced.

  • Page 15: Cleaning And Maintenance

    Cleaning and Maintenance  The device, battery, and charger are not water-resistant. Keep them dry. Protect the device, battery, and charger from water or vapor. Do not touch the device or the charger with a wet hand. Otherwise, it may lead to a short circuit, a malfunction of the device, and an electric shock to the user.

  • Page 16: Eu Regulatory Conformance

    EU Regulatory Conformance Hereby, Huawei Technologies Co., Ltd. declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. For the declaration of conformity, visit the Web site www.huaweidevice.com/certification. Notice: Observe the national local regulations in the location where the device is to be used.

Table of Contents