Table of Contents
Advertisement
en Microwave
a The display shows the start time. The appliance is in
standby mode.
a Once the start time has been reached, the appli-
ance starts heating and the cooking time starts
counting down.
a When the time has elapsed, a signal sounds. A
message appears on the display confirming that the
operation has finished.
Once the cooking time has elapsed:
5.
If required, you can select other settings and re-
‒
start the operation.
When the food is ready, use
‒
pliance off.
Setting the end time
To achieve good cooking results, only change the set
time before the operation starts and before the cooking
time starts counting down.
Press "End time".
1.
Use
or
to change the time or enter the time dir-
2.
ectly via the number field
Press "Apply".
3.
Cancelling the end time
You can delete the set time at any time.
Press "Stop"
1.
Press "End time"
2.
Use
to reset the time.
3.
Note: For operating modes that always require a
cooking time, the appliance resets the time at which
the cooking time ends to the next possible time.
Press "Start"
4.
Microwave
11 Microwave
You can use the microwave to cook, heat up, bake or
defrost food very quickly.
11.1 Cookware and accessories with
microwave
To heat food evenly and avoid damaging your appli-
ance, it is important to only use the right cookware and
accessories.
Follow the cookware manufacturer's instructions.
Unless otherwise specified, place the cookware and
accessory on level 1.
Microwave-safe cookware
Cookware made from heat-resistant, microwave-safe
material:
¡ Glass
¡ Glass ceramic
¡ Porcelain
¡ Temperature-resistant plastic
¡ Fully glazed ceramic without cracks
16
to switch the ap-
.
10.3 Setting the timer
The timer runs independently during the operation. You
can set the timer when the appliance is switched on or
off, up to 24 hours. The timer has its own signal so that
you can tell whether it is the timer or a cooking time
that has elapsed.
Press the
button.
1.
To set the timer, press the relevant time value on
2.
the display, e.g. hour display "h" or minute display
"min".
a The selected value is marked in blue.
Set the timer
using the number field.
3.
If required, use
to reset the setting value.
Press "Start" to start the timer.
4.
a The timer counts down.
a The timer remains visible on the display if the appli-
ance is switched off.
a When the appliance is switched on, the display
shows the settings for the current operation. The
timer is displayed in the status bar.
a Once the timer has elapsed, a signal sounds. A no-
tification appears on the display confirming that the
timer has finished.
Changing the timer
You can change the timer at any time.
Press the
button.
1.
Press "Stop".
2.
Change the timer.
3.
Press "Start".
4.
Cancelling the timer
Press the
button.
1.
Press "Stop"
2.
Reset the timer using
3.
Press
.
4.
¡ Serving dishes
Only use cookware with decorative gold or silver
trim if the manufacturer guarantees its suitability for
microwave use.
¡ Supplied wire rack
In microwave-only operation, sheets and trays, e.g.
the universal pan or the baking tray, may create
sparks and are not suitable.
These materials allow microwaves to pass through and
are not damaged.
Cookware that is not microwave-safe
Note: Observe the specifications for preventing mater-
ial damage.
→ "Microwave", Page 6
¡ Metal cookware and bakeware
Microwaves cannot pass through metal. The food is
barely heated or not heated at all. Metal may create
sparks in microwave-only operation.
.Reset the timer using .
Advertisement
Table of Contents
