Smeg CA129B Instruction Manual page 36

FAULT
E6
6 flashes
E7
7 flashes
E8
8 flashes
E9
9 flashes
In some cases, the alarm signal may indicate a temporary problem, so
before contacting the after-sales service, proceed as follows.
•
Open and close the door, or switch the dishwasher off and back on,
and if necessary reprogram it.
If the problem persists, contact the after-sales service.
34
User instructions
Water pump-out malfunction
The appliance does not pump out the water or does
not do so correctly. Check that the drain hose is not
kinked or crushed and that the siphon and filter are
not fouled. If the problem persists, contact the after-
sales service.
Turbine flow-regulator malfunction
(for the relevant models only)
The appliance is not able to "measure" the amount
of water loaded accurately. Interrupt the program
and switch off the dishwasher. Switch the
dishwasher back on, program it again and start
the washing cycle. If the problem persists, contact
the after-sales service.
Alternate washing system malfunction
Interrupt the program and switch off the dishwasher.
Switch the dishwasher back on, program it again and
start the washing cycle. If the problem persists,
contact the after-sales service.
Water intake system malfunction
Contact the after-sales service.
DESCRIPTION