Smeg CA129B Instruction Manual page 15

User instructions
PROGRAMMING
All programming operations are only possible with the door closed.
To select a new program, the dishwasher must be in the "Program
start" state described above. Turn the PROGRAM SELECTOR (5) to
the program of your choice (see "P T ").
ROGRAMS ABLE
START PROGRAM
Press the START/PAUSE button (3) for a few seconds, until
the START/PAUSE light (4) starts to flash. A beep confirms
the operation.
PROGRAM SEQUENCE
For the entire duration of the program, ON/OFF (2) indicator
light remains permanently on, whereas the START/PAUSE
(4) indicator light flashes.
END PROGRAM
To indicate the end of the program, a short beep sounds
and the ON/OFF (2) and START/PAUSE (4) lights flash.
INTERRUPTION OF A PROGRAM
Press the START/PAUSE button (3) for a few seconds, until
the configuration of the ON/OFF (2) and START/PAUSE (4)
lights is as follows.
You may now restart ("S ") or change the program which
TART PROGRAM
was interrupted.
Some components are live even with the ON/OFF button in the OFF
position. Before maintenance work on the appliance, remove the plug or
turn off the power supply at the wall switch.
13