Smeg CA129B Instruction Manual page 16

TO CHANGE A PROGRAM
To change the running program it is necessary:
•
to interrupt the running program (see "I
•
select the new program;
•
to press again the START/PAUSE button (3) to make start the new
program.
ANNULLING A PROGRAM
To annul the program in progress, it must first be interrupted (see
"I
NTERRUPTION OF A PROGRAM
Turn the PROGRAM SELECTOR (5) to any point on the "empty" sector
(with no symbols) on the left of the selector and start the dishwasher.
After the water has discharged from the tank, the ON/OFF
(2) and START/PAUSE (4) lights will both flash.
If the door is opened with the dishwasher in operation, the
appliance switches to "Pause" state, indicated by a series of
beeps and the following configuration of the ON/OFF (2)
and START/PAUSE (4) lights.
Once the door has been closed again, the "S
already described must be repeated. The washing cycle will restart from
the point where it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
14
User instructions
").
NTERRUPTION OF A PROGRAM
" procedure
TART PROGRAM
");