General Information - Philips 25GR5765 Operating Instructions Manual

VIDEO ~©) AUDIO HEADPHONE f£?
[rv] To connect headphones
(The headphones used must be 8 to
1000 ohm, and 6.3 mm in diameter.)
e Connect the headphones jack-plug
to the (a socket located on the front of
the TV.
note: the loudspeakers are switched
off automatically when the headphones
are connected.
FRONT
REAR
O" O ©
qr LR
[v] To hear the surround sound effect
(Surround sound gives you a 'concert
hall' effect from a stereo sound
broadcast. To hear the surround sound
effect you will need two additional
loudspeakers, ask your dealer for part
number: 22AV1303/01; these must be
connected to the two surround sound
sockets 'REAR' on the back of the TV.)
e Switch off the TV.
e Connect the left loudspeaker plug to
the surround sound 'REAR' socket (L),
and the right loudspeaker plug to the
surround 'REAR' sound socket (R).
e Position the two additional
loudspeakers appropriately.
FRONT
REAR
O" O (6)
qr L R
10
hv] To connect stereo audio devices
(Two stereo audio output sockets on
the back of the TV allow a stereo
device, e.g. a stereo amplifier, to be
connected. Before connecting a stereo
device to the TV, read the operating
instructions supplied with that device.)
e Switch off the TV.
e Connect the appropriate plugs from
the device to the stereo output O»
sockets (L) and (R) on the TV.
TUNING CONTRAST
General information
[v] and ÈJ To store TV stations
directly
(First you must know the frequency on
which the TV station is being
transmitted.)
e Open the control-panel flap on the
TV.
1. Press the P/F button to switch to
frequency setting.
2. Select the frequency using three
digit buttons on the remote control
handset (e.g. to select channel E4; the
digit buttons 062 must be pressed, and
to select channel 69; the digit buttons
855 must be pressed).
3. Press the <> button to display the
program number information.
4. Select a program number using the
digit buttons on the remote control
handset.
5. Press the 2» <> button to store these
changes.
6. Press the P/F button to switch to
program number setting.
e Close the control-panel flap on the
TV.
[vw] To fine tune the picture quality
(The picture from a TV station or a
device such as a video recorder may
be affected by interference, e.g. frorn
other strong signal sources.)
The picture quality may be improved
using the following method:
@ Open the control-panel flap on the
TV.
1. Press the © <> button to display the
program number information.
2. Press the — CD or + LI] button,
and release it immediately, so that the
picture is fine tuned.
3. Press the > <> button to store these
changes.
e Close the control-panel flap on the
TV.
[v] and 22 To change the personal
preference (PP) values
e Open the control-panel flap on the
TV.
e Press the > © button on the TV to
display the program number
information.
e Change the picture and sound
settings (e.g. volume, contrast) using
the remote control handset or TV
controls.
e Press the Y © button on the TV to
store these changes. The program
number information is now removed
from the screen.
e Close the control-panel flap on the
TV.