Troubleshooting Guide - XPower PL-700A Owner's Manual

Troubleshooting Guide

PROBLEM
Low profile air
mover does not
start
Unit runs but the
speed is abnormal
The additional
electrical
receptacle has no
power
The Test Button
doesn't react to
GFCI test based on
the manual
If troubleshooting does not resolve your problem, please contact XPOWER or other
parties authorized by XPOWER for further instructions.
POSSIBLE CAUSE
No electricity.
The power cord is not properly
plugged in.
The machine is working under
an extreme temperature.
The circuit breaker on the
additional electrical receptacle
(Daisy chain) jumps.
Air inlet or air outlet is blocked.
The circuit breaker on the
additional electrical receptacle
(Daisy chain) trips.
A ground fault causes power
interrupt by GFCI.*
A ground fault causes power
interrupt by GFCI.*
SOLUTION
Check for power supply.
Remove and reconnect the
power cord.
Turn off the machine and
unplug it. Let the machine
cool down to normal
temperature.
Remove all appliance on
the additional electrical
receptacle and press "Reset".
Remove blockage.
Remove all appliances on
the additional electrical
receptacle and press circuit
reset button.
Turn off and unplug the
Air Scrubber. Remove all
appliances on the additional
electrical receptacle and
press GFCI reset button.
English - 9