HP 732pk Maintenance And Service Manual page 28

Image appears
blurred, indistinct, or
too dark.
"Input Signal Not
Found" is displayed
on the screen.
"Input Signal Out of
Range"is displayed on
screen.
The monitor is off but
it did not seem to
enter into sleep mode.
"OSD Lockout" is
displayed
"Power Button
Lockout" is
displayed.
The USB ports do not
work, but the monitor
is turned on.
No power from the
USB Type- C or USB
Type-A ports when
the monitor is in sleep
mode.
The desktop
computer does not
turn on.
26
Video cable is improperly connected.
System is in Sleep Mode.
Video card is incompatible.
Brightness is too low.
The monitor video cable is disconnected. Connect the appropriate
Video resolution and/or refresh rate are
set higher than what the monitor supports.
Auto-Sleep Mode is not turned on.
The monitor's OSD lockout function is
enabled.
The monitor's Power Button Lockout
function
is enabled.
There is no upstream USB connection.
The monitor is in Power Saver mode.
The monitor is turned off.
The monitor is in sleep mode.
seconds to disable the
Power button lockout
feature.
Connect the video cable
properly.
Press any key on the
keyboard or move the
mouse to exit sleep mode
Open the OSD menu and
select the Input menu.
Set Auto- Switch Input to
Off and manually select
the input.
Open the OSD menu and
select Brightness to adjust
the brightness scale as
needed.
video signal cable between
the computer and monitor.
Be sure that the computer
power is off while you
connect the video cable.
Change the settings to a
supported setting.
Open the OSD menu and
select Power. Then select
Auto- Sleep Mode and set
auto-sleep to On.
Press and hold the Menu
button on the front bezel for
10 seconds to disable the
OSD Lockout function.
Press and hold the power
button for 10 seconds to
disable the Power Button
Lockout function.
Be sure that the host
computer is connected to
the monitor with a USB
Type-C to USB Type-C
cable or a USB Type-C to
.
USB Type-A cable
Open the OSD menu,
select Power, and then
change the power mode to
Performance.
Be sure that the monitor
power cord is plugged into
an AC outlet and press the
monitor power button.
Press any key on the
keyboard or move the
mouse to exit sleep
mode.