@ Removing the Speaker Board (See Fig.25)
- Prior to performing the following procedure, remove the
metal cover, the CD changer mechanism assembly and
the rear panel.
+ The following procedure can be performed even if the
front panel assembly is attached.
1. Pull out the speaker
board
upward
from
connector
CN205 on the power board.
m@ Removing the Power Transformer Board
(See Fig.26)
: Prior to performing the following procedure, remove the
metal cover, the CD changer mechanism assembly and
the rear panel.
1. Disconnect
the
5P
harness
and
the
flat wire
from
connector CN206 and CN207 on the power board.
2. Remove
the
four
X
screws
attaching
the
power
transformer assembly.
3. Push the cord stopper upward to remove it.
MX-J30/MX-J330/MX-J35R
Power board
CN205
CN201
Speaker board
CN204
Power amplifier board
Rated voltage board
Fig.25
CN207
X
CN206
X
Power transformer board
Cord stopper
Fig.26