Toro RT600 Installation Instructions page 2

2. Using the lifting equipment, remove the counterweights
from the mounting frame.
3. Use lifting equipment to raise or lower the mounting
frame until the holes in the mounting frame align with
the holes in the machine; refer to Figure 1.
Figure 1
1. Mounting frame
2. Hole (mounting frame)
4. Apply medium-grade (service removable)
thread-locking compound to the threads of the bolts
(1-1/4 x 3-1/2 inch).
3. Hole (machine chassis)
5. Install the bolts (1-1/4 x 3-1/2 inch) and washers
(1-1/4) that fasten the mounting frame to the machine
(Figure 2), and hand tighten all of the bolts.
2
1
1. Washer
6. Torque the bolts (1-1/4 x 3-1/2 inch) that fasten the
mounting frame to the front of the machine to 1220 to
1491 N-m (900 to 1100 ft-lb).
7. Torque the bolts (1-1/4 x 3-1/2 inch) that fasten the
mounting frame to the sides of the machine to 1220 to
1491 N-m (900 to 1100 ft-lb).
8. Remove the lifting equipment from the mounting
frame.
2
1
2
Figure 2
2. Bolt
1
2
1
2
g022274