Ferrari 812 competizione A 2024 Owner's Manual page 22

●
Low engine oil pressure.
●
Inertia switch triggered.
●
DTC safety warnings.
●
EPB deactivation warning.
If the next scheduled maintenance deadline is approaching, each time
the key is turned to on, information on scheduled maintenance is
automatically displayed after diagnosis. For further information, see the
"Maintenance Schedule" in the "Warranty Booklet".
Finally, each time the key is turned to on, the message for activation of
the alarm when an intrusion has been attempted is also displayed (after
diagnosis).
Once the system check has been completed, the gearbox display is
activated and the letter "P" (Parking) or "N" (Neutral) will be displayed.
Important note
If the gearbox warning light
indicating a fault in the gearbox (which is also indicated by a symbol
and specific message on the left TFT display), contact the F
S N .
ERVICE ETWORK
"Key-Less" ignition system
The new Ferrari keys use a Key-Less vehicle ignition system which can
be used to switch on the instrument panel and the engine by simply
placing the key inside the vehicle near the driving area. The dedicated
ECU recognises the vehicle key by the electronic ID code it contains. The
ENGINE START/STOP button on the steering wheel controls KEY-ON,
KEY-OFF, ENGINE START and ENGINE STOP.
Moving the vehicle
22
does not turn off after diagnosis,
ERRARI
●
KEY-ON: to activate the vehicle system (instrument panel, air
conditioning and heating system, infotainment system, etc.), press
and quickly release the ENGINE START/STOP button on the
steering wheel.
●
KEY-OFF: to deactivate the vehicle system without starting the
engine, press the ENGINE START/STOP button again WITHOUT
pressing the brake pedal if the previous state was KEY ON; it can
also be pressed if the previous state was ENGINE ON.
●
ENGINE START: to switch on the engine, press down the brake
pedal and press the ENGINE START/STOP button on the steering
wheel.
Important note
Hold the brake pedal down while starting the engine.
●
ENGINE STOP: to switch off the engine when the vehicle is
stationary, press the ENGINE START/STOP button on the
steering wheel.
If the vehicle is in motion and the engine has to be switched off in an
emergency situation, press the ENGINE START/STOP button and hold
it down for at least 2 seconds (alternatively, press the button quickly 3
times in succession).
If the key battery has a charge level that is only just sufficient, the
vehicle informs the driver via a message on the left hand TFT display of
the instrument panel and recommends replacing the battery as soon as
possible. If the battery is flat or the key is not recognised, perform the
emergency switching off procedure.
Warning
If the door closing button on the key is pressed when inside the vehicle,
the engine start function is disabled. The door opening command must