Ferrari 812 competizione A 2024 Owner's Manual page 42

●
Position the vehicle on an even surface, then block the rear wheels
by applying the parking brake.
Warning
Make sure that the vehicle is in a safe position by applying the parking
brake.
●
If necessary, switch on the hazard warning lights and place the
hazard triangle at the required distance from the vehicle.
●
Take the space saver spare wheel and tools out of the luggage
compartment.
●
Loosen the five wheel fastening stud bolts by approximately one
turn, using the wrench
●
Place the base of the jack
lifting points F on the underfloor as shown in the figure.
●
Raise the vehicle carefully using jack
ground.
Towing the vehicle
42
D supplied.
E on flat firm ground under one of the
E until the wheel is off the
F
E
D
Warning
Before replacing one or more wheels, make sure no one is in the vehicle.
If the jack is not positioned correctly, the vehicle could slip off. Make
sure that no part of the body is underneath the vehicle while changing
the wheel. The supplied jack must only be used for changing wheels.
●
Unscrew the five stud bolts and remove the wheel.
●
Fit the uninflated collapsible spare wheel.
●
Screw the stud bolts into place but do not tighten them.
Warning
Inflate the collapsible spare wheel before lowering the vehicle to avoid
damaging the rims.
●
Inflate the collapsible spare wheel using the "Emergency tyre
inflation and repair kit".
Warning
The kit must be used in "tyre inflation" mode. Refer to the instruction
manual supplied with the kit.
●
Inflate the spare wheel to the indicated pressure.
●
Lower the vehicle and remove the jack.
●
Tightly fasten the stud bolts, alternately going from one stud bolt to
one that is diametrically opposite.
As soon as possible, tighten the stud bolts with the torque wrench to a
torque of 120 Nm.