Ranger RP-50FC Installation And Operation Manual page 4

⚠
WARNING
Hydraulic System Warnings
Before applying power to the Hydraulic System note the following Warnings:
⚠
WARNING
⚠
WARNING
⚠
WARNING
⚠
WARNING
⚠
WARNING
⚠
WARNING
⚠
WARNING
⚠
WARNING
⚠
WARNING
RP-50FC High-Speed Oil Filter Crusher
California Proposition 65. This product can expose you to chemicals including
styrene and vinyl chloride which are on the list of over 900 chemicals identified by the State
of California to cause cancer, birth defects or reproductive harm. ALWAYS use this
product in accordance with BendPak's instructions. For more information go to
www.P65Warnings.ca.gov.
Failure to observe these warnings can result in serious personal injury including, in
rare cases, death.
Verify all Hydraulic Hose connections and fittings, including unused auxiliary port
plugs on the Power Unit, the Flow Divider, the Cylinders and anywhere else in the
Hydraulic System are tightened.
The Power Unit is a Hydraulic Pump capable of developing high pressures. A
pressure relief valve is used to set the pressure at the desired level. Tampering with,
adjusting, modifying, or removing the relief valve is extremely dangerous and is not
recommended. Only trained Hydraulics technicians should make adjustments to the
relief valve, using calibrated hydraulic pressure gauges to assure the proper
pressure setting is achieved.
Changes to the output pressure may render the power unit incompatible with pressure
limitations of other components in the hydraulic circuit. This may cause catastrophic
failure of those components, and could result in property damage, serious personal
injury, or death.
The Hydraulic System can contain high pressure which, if suddenly released, can
cause serious injury or death.
Do not attempt to connect or disconnect Hydraulic Hoses while the equipment is
loaded, or the Hydraulic System is under pressure.
Keep bare hands away from Hydraulic Fluid; always wear gloves when handling
Hydraulic Fluid, Cylinders or Hydraulic Hoses.
When handling Hydraulic Fluid, always observe the safety instructions from the
manufacturer.
Always promptly clean any Hydraulic Fluid spills. If a leak is the source of the spill,
do not use until the Hydraulic System is repaired.
4
P/N 5900392 — Rev. C4 — March 2023