Operation - Ranger RP-50FC Installation And Operation Manual

Operation

The correct way to press any of the three control buttons is to press firmly and then release. Pressing
and holding
There are three control buttons on the oil filter crusher:
Reverse button, blue. Returns the press ram to its original starting position.
•
Stop button, red. Stops all movement of the press ram if it is in use. The red button is
•
your emergency stop.
• Start button, green. Activates the automatic pressing cycle. When an automatic pressing
cycle is started, the press ram moves down, contacting the item you are crushing. When it reaches
maximum crushing depth, the press ram automatically stops and returns to the starting position.
⚠
WARNING
To operate your oil filter crusher:
1. Place an approved waste oil container under the oil drain (which is on the underside of the
reservoir base).
2. Lift the sliding door firmly and place an empty filter or paint can in the center of the chamber,
end down
⚠
WARNING
3. Close the sliding door.
⚠
CAUTION
4. Press and release the green button; an automatic cycle begins.
When the automatic cycle starts, step back from the unit.
The press ram will move downwards, crush the item, return to the original starting position, and
then shut off.
5. To remove the crushed filter, open the sliding door and pull out the crushed item.
⚠
CAUTION
⚠
WARNING
6. Put the breaker switch (on the left side of the unit) to the off position when the unit is not in use.
⚠
CAUTION
RP-50FC High-Speed Oil Filter Crusher
the control buttons can cause damage to the unit.
Avoid off-center loads. If the press ram seems to be laboring more than usual or the
filter/can is unusually hard to press, stop operation. Do not operate the press ram if
the filter/can tilts or binds during the downward movement of the press head.
.
Crush Hazard! Hold the sliding door open when placing filters in, or retrieving filters
from, the chamber. Do not operate the crusher with the door open. Do not stack
filters or cans inside the crushing chamber.
You cannot crush an item until the sliding door is fully closed.
Do not get distracted when removing a crushed filter. Use industrial gloves to
prevent from scratching, cutting, or puncturing your skin on the sharp edges of the
crushed filter. Watch for leaking oil.
Do not attempt to remove a stuck filter or paint can until you stop the automatic
pressing cycle using the red Stop button.
To prevent the Power Unit components from overheating, we recommend taking
2-3 minute breaks after every half hour of use. The Power Unit's Motor is not
constant duty; it cannot be run continuously.
21
P/N 5900392 — Rev. C4 — March 2023
open