Seiko 5X83 Complete User Manual page 58

7
TROUBLESHOOTING
Troubleshooting
Reception is not started even with
operation of time zone adjustment/
manual time adjustment.
GPS signals cannot be received even
by carrying out GPS signal reception
(The reception result is displayed as
"N".)
Reception is possible (reception result
display becomes "Y"), but the time and
date are not accurate (when it is
GPS signal
understood as a reception result after
reception
time adjustment).
Reception is possible (reception result
display becomes "Y"), but the time and
date are not accurate (when it is
understood as a reception result after
time zone adjustment).
The reception result is displayed as
"Y", but the time is gained or lost by
one to two seconds.
Possible causes
The charging status display is "low". (P. 12)
The in-flight mode ( ) has been set. (P. 32)
You are in a place where GPS signals cannot be received.
The time zone that does not correspond to the region where you are has been
set.
DST (Daylight Saving Time) setting does not correspond to the addition
conditions of DST (Daylight Saving Time).
DST (Daylight Saving Time) setting does not correspond to the addition
conditions of DST (Daylight Saving Time).
The positions of the hands are misaligned due to external influences.
The preliminary positions of the hands are incorrect.
→ Preliminary position P. 51
The automatic time adjustment function has not been activated for a few days. When energy is insufficient, the automatic time adjustment may operate only once every 3 days.
Charge the watch sufficiently until the multi-indicator hand returns to
the day of the week display from a charging status display of "low."
After relocation from a place under restriction on use of GPS signals (in an airplane, etc.), reset the in-
flight mode ( ).
(P. 18) Receive GPS signals in a place where GPS signals can be easily received.
Check the time zone setting.
If the time zone does not correspond to the region where you are, adjust the time zone.
• When you are in a place where GPS signals can be easily received → How to adjust the time
zone P. 22
• When you are in a place where GPS signals cannot be received → How to manually set the time
zone P. 25
Check DST (Daylight Saving Time) setting.
Do the time zone adjustment when you are in a place where it is easy to receive GPS signals.
→ How to adjust the time zone P. 22
Check DST (Daylight Saving Time) setting.
Do the time zone adjustment when you are in a place where it is easy to receive GPS signals.
→ How to adjust the time zone P. 22
① <Hour/minute hand misalignment> The automatic hand position adjustment function is activated to
automatically adjust the positions. Please use the watch as it is. The automatic hand position
alignment function is activated once every 10 minutes for the seconds hand, once an hour for the
minute hand, and once every 12 hours for the hour hand.
<Date misalignment> Since the preliminary position is not automatically adjusted, manually adjust
the position.
② If the hand misalignments are not corrected, refer to "When the sub-dial, stopwatch 1/20-second
hand, multi-function indicator hand, date, or hour/minute/seconds hand position is misaligned" and
perform the operations.
③ When misalignment of the hand is not adjusted even with operation of 2, consult the retailer from
whom the watch was purchased.
57
5X83 GPS SOLAR
Solutions
middle
Reference pages
P. 14
P. 32
P. 18
P. 27
P. 22
P. 25
P. 27
P. 22
P. 27
P. 22
P. 51
P. 52
P. 31