Electrolux EEG68500L User Manual page 25

Hide thumbs Also See for EEG68500L:
Table of Contents

Advertisement

Available languages

Available languages

Problem and alarm code
The appliance does not fill with wa‐
ter.
The display shows i10 or i11.
The appliance does not drain the
water.
The display shows i20.
The anti-flood device is on.
The display shows i30.
Malfunction of the water level detec‐
tion sensor.
The display shows i41 - i44.
Malfunction of the wash pump or the
drain pump.
The display shows i51 - i59 or i5A -
i5F.
The temperature of the water inside
the appliance is too high or malfunc‐
tion of the temperature sensor oc‐
curred.
The display shows i61 or i69.
Technical malfunction of the appli‐
ance.
The display shows iC0 or iC3.
The level of water inside the appli‐
ance is too high.
The display shows iF1.
The appliance stops and starts
more times during operation.
The programme lasts too long.
The displayed programme duration
is different than the duration in the
consumption values table.
The remaining time in the display in‐
creases and skips nearly to the end
of the programme duration.
Possible cause and solution
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too low. For this
information, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
Make sure that the sink spigot is not clogged.
Make sure that the interior filter system is not clogged.
Make sure that the drain hose has no kinks or bends.
Close the water tap.
Make sure that the appliance is correctly installed.
Make sure the baskets are loaded as instructed in the user manual.
Make sure that the filters are clean.
Switch the appliance off and on.
Switch the appliance off and on.
Make sure that the temperature of the inlet water does not exceed
60°C.
Switch the appliance off and on.
Switch the appliance off and on.
Switch the appliance off and on.
Make sure that the filters are clean.
Make sure that the outlet hose is installed at the right height above the
floor. Refer to the installation instructions.
It is normal. It provides optimal cleaning results and energy savings.
If the delay start option is set, cancel the delay setting or wait for the
end of the countdown.
Activating options increases the programme duration.
Refer to the consumption values table in the chapter "Programme se‐
lection".
This is not a defect. The appliance is working correctly.
ENGLISH
25

Advertisement

Chapters

Table of Contents
loading

Table of Contents