Table of Contents
Advertisement
1
1.1
1.2
1.3
ATTENTION
Note!
1.4
Mounting instructions, UDHOME2 with tube body
About these instructions
Target group
These instructions are intended for the following target groups:
Trained electrical specialists charged with mounting floor sockets.
–
Electrical planners and engineers charged with the planning of under-
–
floor systems.
Electrical work may only be carried out by specialist personnel with elec-
trical training.
Relevance of these instructions
These instructions are based on the standards valid at the time of compi-
lation (February 2021).
Please read the instructions carefully before starting installation. We will
not accept any warranty claims for damage caused through non-obser-
vance of these instructions.
Any images are intended merely as examples. Mounting results may look
different.
All the documents supplied with the product must be stored in an easily
accessible location, so as to be available when information is required.
Types of warning information
Type of risk!
Shows a hazardous situation. If the safety instruction is not observed,
then damage to the product or the surroundings may occur.
Indicates important information or assistance.
Basic standards and regulations
– DIN EN 50085-1: Electrical installation trunking systems for electrical
installations – Part 1: General requirements
– DIN EN 50085-2-2: Electrical installation trunking systems for electri-
cal installations – Part 2-2: Particular requirements for cable trunking
systems and cable ducting systems intended for mounting underfloor,
flushfloor or onfloor
– DIN EN ISO 9001:2008
– DIN EN ISO 14001:2008
About these instructions
5 | EN
Advertisement
Table of Contents
