Applying The Floor Covering And Adjusting The Height - OBO Bettermann UDHOME2 Mounting Instructions

Applying the floor covering and adjusting the height
8
ATTENTION
ATTENTION
ATTENTION
ATTENTION
16 | EN
4. Lay the screed flush to the top edge of the mounting protection cover
10
and work it up to the floor socket
5. Cut open 2 the mounting protection cover
The paper strips at the side do not need to be removed.
6. Open the cover plate
Applying the floor covering and adjusting the
height
Risk of damage through joint mortar!
Contact between the floor socket and joint mortar leads to product dam-
age! When applying joint mortar to the expansion joint along the floor
socket, the frame and cover must be protected against the joint material.
Risk of damage from joint material/adhesive!
The ingress of the joint material/adhesive into the floor socket can lead to
product damage! Thoroughly clean the interior after floor covering work.
Risk of damage!
Adjustment of the floor socket to an excessive height can lead to product
damage! Only adjust the height of the floor socket to the maximum ad-
justment height (H max). Ensure a maximum of 135 mm (screed + floor
covering)
Risk of damage through insufficient expansion joint!
An expanding floor covering without a sufficient expansion joint leads to
product damage! Work the floor covering up to the floor socket housing
with no tension. To achieve this, fill a sufficient expansion joint with per-
manently elastic joint material.
1
.
4
.
10
with a carpet knife.
OBO Bettermann