Operation; Preparation; Maintenance; Check Before Each Use - Zionair SB99A Assembly And User Instructions Manual

5. Connect the air hoses as shown in the picture.

4. Operation

Preparation

1. Before you can start sandblasting make sure the workpiece is free of oil, water and moisture,
make sure the workpiece is dry and clean.
2. Set the work pressure of the compressed air between 5.5 and 8.6 bar, 8.6 bar is the
maximum work pressure, grit breaks down faster with a higher work pressure. ADVICE: Start
with a working pressure of 5.5 bar, most work pieces can be blasted easily with this
pressure. For light steel, aluminum and other fine work pieces you can better start at a low
working pressure and if necessary adjust the pressure higher for the optimal result.
3. The grit should be of good quality, this is probably even more important than it to be moist
free. Moist grit clutters, which causes a bad flow and clogging.
4. You can also choose to use a bigger or smaller size nozzle. A bigger size nozzle gets the job
done faster because it can blast a larger surface, this also causes a higher air consumption,
make sure the compressor can handle it.
Operation
1. Keep the blasting gun at an angle of 45-60° towards the work piece at a distance of 10-15cm
with the nozzle pointing towards the backside of the cabinet. Never hold the gun in a 90°
toward the work piece, this causes the grit to rebound back into the spray, which causes a
less effective spray. This also causes extra wear to the gun and viewing glass.
2. The blasting gun should always point away from the operator towards the work piece.
3. It is strongly forbidden to start sandblasting when the cabinet is not fully closed (open
door/cover) or when the dust extractor and or light is not on.
4. Before placing/removing a workpiece , make sure to turn off the compressed air supply by
closing the air valve.

5. Maintenance

WARNING! Before performing maintenance, remove the plug form the power source, failure to
heed this instruction may cause electrocution. Close the valve of the compressed air supply.

Check before each use

Check the sandblasting cabinet previous to each use for damaged and/or deformed parts. Check all
hoses for wear and tear and check if the nozzle is not too worn. Check if the dust extractor works
well, clean it if necessary, finally also check if the doors/covers still close properly. In case of a
malfunction/defect, do not use the sandblasting cabinet until it has been repaired.
12