Daintree GE current Arize Lynk2 Installation Manual page 4

Arize Lynk
2
TM
METHOD 1
Single Luminaire Installation
Before starting:
Luminaires must only be mounted using Current's standard or slim mounting clips (see Components Required on page 3).
Mounting instructions using Current's standard and slim mounting clips.
Align using chalk line,
laser projector or similar
Secure each luminaire mounting clip to a rigid flat
1
mounting surface using two #10 (M5) self-tapping
flathead screws along the intended run of luminaire.
To avoid stress and damage to luminaire the
entire mounting surface should be flat and the
mounting clips be properly aligned. Refer to table
on page 11 for required number of mounting clips
per luminaire.
Male connector towards
electrical supply
Place the luminaire on the surface with the
3
male connector oriented towards the intended
electrical supply.
Go to METHOD 3 on page 7
SNAP!
Press the luminaire into its mounting clips so that
2
the male connector is oriented towards the intended
electrical supply. TIP: Align luminaire on one side of
the mounting clips; then rotate the luminaire until it
snaps into other side of the mounting clips.
(Only for single luminaire installation)
Alternately: The required mounting clips may first
be pressed onto the luminaire, then the luminaire
mounting clip assembly may be mounted on to the
mounting surface using two #10 (M5) self-tapping
flathead screws per mounting clip.
2
4 If not already covered, insert an end cap into the
female connector, and twist the end cap clockwise to
secure.
4
Installation Guide
SNAP!
Rotate and Push
1