Table of Contents
Advertisement
Page 34
{ ) Refer to Detail 3-1A and position the main and
power supply circuit boards as shown. Then
mount the power supply board on spacers A,
B, C, and D with 6-32 x 1/4" pan head screws.
Refer again to Pictorial 3-1 for the following steps.
NOTE: When you solder a wire to the foil in the
following steps, lay the bare end flat on the foil and
solder it to the foil. If the wire tries to spring up
off the foil, hold it down with the blade of a screw-
driver until the solder cools.
Connect the wires coming from the power supply
board to the main board in the following steps:
( ) White wire from M to foil EE (S-1).
{ ) Yellow wire from L to foil FF (S-1).
( ) Green wire from K to foil GG (S-1).
Heathkit
Blue wire from D to hole 17 (S-1).
Orange wire from A to foil LL (S-1).
White wire from B to foil KK (S-1).
Black wire from C to foil NN (S-1).
Detail 3-1A
Advertisement
Table of Contents
