Heathkit ET-1000 Manual page 37

SOCKET
Refer to Detail 3-1B for the following steps.
{ ) Twist together a 14" brown and a 14" red solid
wire. Remove 1/8" of insulation from both
wires at one end, and 3/16" from the wires at
the other end.
( ) Refer to the inset drawing and install large
connectors on the.3/16" stripped ends of these
wires, and small connectors. on the 1/8"
stripped ends, as shown in the inset drawing.
( ) Remove 3/16" of insulation from both ends of
a 16" red stranded wire. Install a large connec-
tor on one end only.
In the following steps, you will insert the connectors
that are on these wires into a 4-hole and small 2-hole
socket. Be sure to position the sockets with the slot-
ted side up and the connectors with the small tab
up when you insert them. Make sure the tab snaps
into place.
INSET
CRIMP OVER BARE
END OF LEAD
AND
16" RED
STRANDED
Page 35
i.
CRIMP OVER
MC iseren SUD
AFTER
SOLDER
SPRING
or ge tieest
COOLS
CONNECTOR
SLOTTED
NYLON
DO NOT GET
SIDE PLUG
SOLDER pee.
4-HOLE
THE SPRIN
SOCKET! 5
Z 4
TAB
aI
4-Hole Socket
( ) Red wire in hole 1.
( ) Brown wire in hole 2.
Refer again to Pictorial 3-1 for the following steps.
wire as shown and solder it to the foil at MM.
Set the assembly aside temporarily.