DUCT VENT CAP
4" DUCT VENT CAP
APPLIANCE BRUSH SET
FOR CLEANING INSIDE THE FILTER AREA
6 | GE PROFILE UltraFast Combo Accessories Guide |
• Durable bump & heat resistant PVC construction
• Used to terminate a round 4" duct previously used
by a vented dryer.
• Readily fits a 4" duct pipe and can be fastened with
a flat head screwdriver with the included hose
clamp.
1. Clean any debris that is in the duct line and discard
the old ducting from your previous dryer, if
applicable.
2. Install the PVC cap onto the open duct protruding
from the wall.
3. Using a flathead screwdriver, tighten the hose
clamp to secure it to the duct.
• Maintain efficiency with a set of brushes that
make cleaning hard-to-reach areas easy
• Designed for the Combo and conventional dryer
venting and more.
Watch this video to see how
these brushes are used in
the cleaning of the Combo
filter area.
www.geappliances.com
WX08X10070
PM14X10056