GE Profile UltraFast Combo PFQ97HSPVDS Accessories Manual page 14

1' HOSE SPLITTER 2 WAY WX14X10014
SHORT HOSE with Y-ADAPTER (2 NEEDED)
x
12 | GE PROFILE UltraFast Combo Accessories Guide |
2
• Provides ability to split either the HOT or COLD
water supplies. Two kits requires for this installation.
• Kit includes: 1' stainless steel hose, y-adapter with
male threaded connections, two rubber washers.
Compatible with rubber or stainless steel hoses.
1. Remove the hose from the pack and install the
rubber washers in each end. Install the top end of
the y-adapter onto one end of the hose.
2. Assemble the open end of the hose onto either the
HOT or COLD water faucet. It may help to label this
hose to recall if HOT or COLD is the input.
3. Tighten, but do not overtighten, the fitting at the
faucet.
4. Repeat steps 1-4 for the second kit.
5. Using 2 sets of supply hoses – total of 4 four (sold
separately) for the Combos, attach the hoses to the
y-adapters, making sure to separate one set of HOT
and COLD for each Combo.
6. Connect hoses to each Combo, ensuring to attach
HOT to HOT (red) and COLD to COLD (blue).
7. Tighten, but do not overtighten, all the fittings.
8. Turn on the faucets slowly, checking for leaks. If
needed, reinstall any hoses/fittings.
9. Next, check the sizing of your standpipe and
confirm that the diameter is at least 2.0" and that
the opening is between 24 - 96" off the floor.
10. Install the first drain tube into the standpipe,
inserting it between 4 – 7" into the pipe.
11. Install the second Combo's drain tube 4-7" into the
standpipe next to the other drain tube. If the ID of
the pipe is at least 2" , they should pass each
easily. If the ID is closer to 1.5", you may need to
initially squeeze one tube to get the rubber end
into the pipe to get it started.
12. Secure each drain tube properly using zip-ties so
that they do not move during usage.
www.geappliances.com