GE Profile UltraFast Combo PFQ97HSPVDS Accessories Manual page 5

RISER
(continued)
4. JOIN REAR BRACKETS
▪ Lift riser and hook front brackets of the
riser to front brackets of the Combo.
▪ Align front and rear brackets on Combo
with front and rear brackets on the riser
and loosely fasten the screws. Make sure
the bracket from the Combo is to the
INSIDE of the riser bracket and not the
outside.
5. LEVEL THE COMBO
▪ Locate the 4 legs from the parts package
and install TO MINIMUM HEIGHT.
▪ Stand the Combo upright.
▪ Securely tighten all screws in all brackets.
▪ Make sure the Combo is level by placing a
spirit level on top. Check side to side and
front to back.
▪ Use a 9/16" open
ended wrench to
adjust the legs in
and out. Tighten
the lock nut
against the bottom
of the riser.
NOTE: To minimize vibration the locking
nuts must be tight.
6. ADJUST COMBO LEGS
▪ Snug the feet of the Combo to the top of
the riser to minimize vibration.
7. REMOVE SHIPPING BOLTS & BRACE
▪ Remove the 4 shipping bolts on the back
side of the Combo and the top brace.
8. FINALIZE THE INSTALLATION
▪ Refer to the Combo installation
instructions to complete the installation.
GE PROFILE UltraFast Combo Accessories Guide | www.geappliances.com | 3