Advertisement
Installing the faucet
1.
Choose a suitable place for the faucet near the sink.
2. Drill a hole with a diameter of 12 mm in the worktop.
3. Fit the washers, plates, gaskets and nuts in the se-
quence shown in the illustration and screw them to
the worktop.
4. Attach the clean water hose to the underside of the
faucet and connect it to the appliance.
5. Install the faucet at the desired location as shown in
the illustration. Either on the left or right side, de-
pending on the faucet.
Maintenance
Regular maintenance is required to ensure optimum operation of the appliance. The frequency of
maintenance depends on the quality of the feed water and the extent to which the system is used. Below
are some guidelines for scheduled filter changes, although the frequency of filter changes may vary. If
in doubt, contact a service technician.
•
Change PP sediment filters every 3–6 months or as required
•
Replace bayonet filters every 18–24 months or as required
•
Replace carbon block filter every 6–12 months or as required
•
Change the activated carbon granulate filter every 6–12 months or as required
Disconnect the appliance from the power supply if you will not be using it for a longer period of time or
if you will be absent. If the appliance has been switched off and has not been used for a long time, carry
out the same rinsing process as when it was first switched on
Troubleshooting
Problem
No water production
Leakages
Important notice:
The reprint or reproduction, even of excerpts, and any commercial use, even in part, of this instruction
manual require the written permission of WilTec Wildanger Technik GmbH.
https://www.naturewater.eu
Possible cause
Filter cartridge clogged
Feed water valve is closed
Flowing water is shut off
Pipe not tightly connected
Item 64422, 64423
Suggested solution
Replace cartridge.
Open feed-water valve.
Open water supply.
Tighten fitting.
Page 7
01 2024-1
Advertisement
