Table of Contents
Advertisement
Operation Manual
ARTICLE Pressure filter CPF-Series
Item number 50123, 50105, 51042, 51043, 50977, 51044, 50121, 50978, 50979,
50980
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignificantly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Table of Contents
Related Manuals for WilTec Sunsun CPF Series
Summary of Contents for WilTec Sunsun CPF Series
- Page 1 Operation Manual ARTICLE Pressure filter CPF-Series Item number 50123, 50105, 51042, 51043, 50977, 51044, 50121, 50978, 50979, 50980 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignificantly.
- Page 2 The information contained in this document is subject to change without prior notice. No part of this document can be copied or duplicated in another form without the prior written consent of WilTec Wil- danger Technik GmbH. The WilTec Wildanger Technik GmbH assumes no liability for any errors in this user manual or the connection diagram.
- Page 3 You have to make sure that the filter is not exposed directly to sunlight. • The pond pressure filter has to be horizontally fixed with screws on a suitable mounting place. © by WilTec Wildanger Technik GmbH Seite 3 http://www.WilTec.de http://www.aoyue.eu...
- Page 4 11. In frosty weather please remove the UV-Filter. 12. When you install the UV-Filter do not expose it to direct sunlight. 13. Dirt influences the efficiency of the quartz glass tube; therefore it needs to be regularly cleaned. © by WilTec Wildanger Technik GmbH Seite 4 http://www.WilTec.de http://www.aoyue.eu...
- Page 5 • When no water is conveyed the device must be switched off. • By frosty weather the device must be removed and kept dry in a place free of frost. © by WilTec Wildanger Technik GmbH Seite 5 http://www.WilTec.de http://www.aoyue.eu Februar 2020 Version 2 http://www.teichtip.de...
- Page 6 Water flow from the filter into the pond Clean water outlet from the filter to waste water or flower bed The Wiltec pressure filter is an ideal filter system for your garden pond. The filter has more advantages ◊ high cleaning capacity ◊...
- Page 7 Lamp. After the cooling, it is automatically started. The Wiltec filter is delivered with all the necessary filter mats. Wash the filter mats with pond water carefully before using. The bio balls (dependent on model)are placed at the bottom in the filter, above comes the grating with the protective tube for the UVC unit.
- Page 8 (closure cap) and gasket seal, as safety, in case the function switch is acci- dentally set on „Clean“. Attention! Do not operate the device without water flow or pump filter! © by WilTec Wildanger Technik GmbH Seite 8 http://www.WilTec.de http://www.aoyue.eu...
- Page 9 In the zones/areas with a high flow speed (blue filter) mainly micro organisms settle that convert ammonium to nitrate. In the areas in which the water flows even faster (yellow filter), mainly anaer- obic micro organisms accumulate themselves that reduce the nitrate to nitrogen. © by WilTec Wildanger Technik GmbH Seite 9 http://www.WilTec.de http://www.aoyue.eu...
- Page 10 By frost the filter has to be removed. Do not expose the filter to the direct sun light. After the filter has been placed on the right place and the pump has been connected the integrated UV- unit can be switched on. © by WilTec Wildanger Technik GmbH Seite 10 http://www.WilTec.de http://www.aoyue.eu...
- Page 11 The UV-unit: The Wiltec Filter is delivered with all the equipment you need and an integrated UV-unit. The UV-PL lamps have ca. 8000 working hours that correspond to a season period of use from March till November. The UV-lamps can be replaced by loosening the screws from the spherical upper part of the cover lid.
- Page 12 Fit the clamp ring around the lid, press on the cover lid and close the sealing clam. CPF-180-250 CPF-280-380-500 CPF-2500-5000-10000-15000-20000-30000 © by WilTec Wildanger Technik GmbH Seite 12 http://www.WilTec.de http://www.aoyue.eu Februar 2020 Version 2 http://www.teichtip.de...
- Page 13 After rinsing all parts are reassembled in reverse order. The pump and the device are connected again to the power supply. The wear parts (Filter materials, light tubes, quartz sleeves, seals) are usually by WilTec Wildanger Technik GmbH www.wiltec.info in stock available.
- Page 14 This logo indicates that this electric equipment must not be disposed with the domestic waste. The company WilTec Technik GmbH has been registrated in the German registry EAR under the WEEE- registration number DE45283704. Disposal of used electrical and electronic appliances...