Helios AIR1-BE TOUCH Installation And Operating Instructions Manual page 17

Installation and operating instructions
413 Timer
NOTE
Controller - AIR1-BE TOUCH/2
– For constant air pressure
Switch between
OFF
NORMAL
TIMER
Home 1
OFF: No ventilation. The unit is in standby mode.
NORMAL: The unit runs at the setpoint specified in the configuration.
TIMER: The unit only runs according to the programmed schedule.
Go back to TIMER: After manual switching to OFF / NORMAL, the unit automati-
cally returns to TIMER-based operation after the time shown in the field.
Programme each we-
ekday by pressing:
MON / TUES / WED
/ THU / FRI / SAT /
SUN / HOLIDAYS
Home 1
HOLIDAY CALENDAR: The holiday calendar has a higher priority than the normal
timer. The unit will run according to the settings for the holiday in each calendar
interval programmed in the holiday calendar. All holidays have the same settings.
Programme timer
ä
Click on the start
and stop buttons to
programme the inter-
val. Up to 4 intervals
can be programmed
per stage for each
weekday
Timer overview
Timer
Recirculation & sensor-controlled operation (VOD) may not be available depen-
ding on the unit configuration. If the unit is operated in constant air pressure
mode, not all ventilation stages will be available. The available ventilation stages
are described in chapter 4.1.2.
5
EN
Select when the unit
should go back to
timer mode.
"Never" means the
unit will not go back
to timer mode.
Holiday calendar:
Define holidays
throughout the year
Copy: Copy the
settings from one
weekday to another
ò
Switch between
the weekday to be
programmed
ù
Switch between
the ventilation stage
to be programmed