Advertisement
Available languages
Available languages
Installation and operating instructions
EN
NOTE
m
DANGER
nm
CHAPTER 2
TECHNICAL DATA
Controller - AIR1-BE TOUCH/2
vibration-free and free of temperature variations. Damages due to improper trans-
portation, storage or putting into ope-ration are not liable for warranty.
17 Intended use
The controller AIR1-BE TOUCH is designed for controlling of device series AIR1-
XC, AIR1-XH and AIR1-RH The controller AIR1-BE TOUCH 2 is designed only
for controlling of device series AIR1-XHP and AIR1-XVP
product and it can only be used once the ventilation system has been properly
installed and connected.
Any use other than the intended use is not permitted!
18 Standstill and disposal
m
Danger to life due to electric shock!
When dismantling, live parts can be exposed, which can result in electric shock
if touched Before dismantling, isolate the unit from the mains power supply and
protect against being switching on again!
Parts and components of the unit, whose service life has expired, e.g. due to wear and
tear, corrosion, mechanical load, fatigue and/or other effects that cannot be directly
discerned, must be disposed of expertly and properly after disassembly in accordan-
ce with the national and international laws and regulations. The same also applies to
auxiliary materials in use. Such as oils and greases or other substances. The intended
and unintended further use of worn parts, e.g. impellers, rolling bearings, filters, etc.
can result in danger to persons, the environment as well as machines and systems.
The corresponding operator guidelines applicable on-site must be observed and used.
21 Technical data
AIR1-BE TOUCH
Voltage
24 V DC
Power consumption
Controller
Operating temperature
Protection class
Humidity
22 Dimensions
192
< 6 W
Front panel made of glass with capacitive
multi-touch interface
-10 +60 °C
IP20
Max 90 % RH (non-condensing)
50,5
2
It is not a ready-to-use
Fig 1
6
159
Advertisement
Chapters
