Installing The Pad-4, Power Supply, And Battery - Siemens NTWRK-ENCL Installation Instructions Manual

Network Enclosure Installation Instructions
2.2

Installing the PAD-4, Power Supply, and Battery

Refer to the following diagram for the placement of the PAD-4, the power supply, and battery:
Figure 2–2: Network Enclosure Component Placement

Power Supply: Mount the Power Supply to the four #10-32 studs as shown in the cabinet
using the four #10-32 nuts provided with the Power Supply.

PAD-4: Mount the PAD4 to the six #6-32 standoffs as shown in the cabinet using the six #6-32
screws provided with the PAD4. Refer to the PAD-4 Manual, P/N 315-050217, for additional
details on the installation of the PAD-4 in the Enclosure.

Batteries: Remove the six ¼-20 nuts and the battery bracket as shown in the cabinet. Set the
batteries with terminals facing each other on the bottom of the cabinet as shown and replace
the bracket and six ¼-20 nuts.
Siemens Industry, Inc.
Smart Infrastructure
6
A6V12412370_en--_a