Packaging; Controls - GE UCC15NPRBII Owner's Manual And Installation Instructions

Packaging

Remove Packaging
IMPORTANT:
instruction labels inside your ice machine or the Tech
Sheet that is fastened behind the kickplate.
before using (except the model and serial number
label).
To remove any remaining tape or glue, rub the area
briskly with your thumb. Tape or glue residue can
also be easily removed by rubbing a small amount of
liquid dish soap over the adhesive with your fingers.
Wipe with warm water and dry.

Controls

1. POWER
will flash until the current icemaking cycle is complete prior to turning off. The icemaker will also drain
2. CLEAN - Press and hold for 3 seconds to start the cleaning process. (See Care and Cleaning)
3. FILTER RESET - Press after changing filter to reset filter timer. (See GSWF Water Filter)
4. WiFi - Press and hold Clean and Filter buttons at the same time. WiFi symbol will start blinking. (See Wifi section)
5. MAKING ICE
6. TIME TO CLEAN
7. Replace Filter
the filter. (See GSWF Water Filter)
Sabbath Mode
The Sabbath Mode was designed for use on the Jewish
Sabbath and Holidays. The icemaker will not make ice
while making ice, icemaker will complete current cycle
icemaker is equipped with a drain pump, it will continue
to work as normal.
Door Alarm
An alert will sound when the door has been left open for
the alert by pressing any button.
6
1 2
6 months indicating it is time to clean the machine. (See Care and Cleaning)
flammable fluids or abrasive cleaners to remove tape
or glue. These products can damage the surface of
3
4
The icemaker will exit Sabbath mode automatically after
96 hours.
ON/OFF - To activate the Sabbath Mode, Press and
5
6
7
49-1000640 Rev. 4