GE UCC15NPRBII Owner's Manual And Installation Instructions page 22

Drain Pump Kit UPK4 Accessory Installation (Cont.)
4
INSTALL NEW DRAIN TUBING
accessories to the drain pump and clamp with
snap ring included in the kit. Please ensure that
the side with arrow faces up during installation.
Snap Ring
Tubing
5
INSTALL THE DRAIN PUMP
the red connector you will see on a wire inside of
the ice machine.
Red Connectors
Slide the drain pump into the ice machine so
the base slides under the tab on the base of the
ice machine floor. The front of the pump with
the hose attached will face the front of the ice
machine.
22
Installation Instructions
Tab
5
INSTALL THE DRAIN PUMP
(Cont.)
from the kit, attach the
pump to the ice maker
floor using a wrench.
6
CONNECT DRAIN PUMP TO ICE
MACHINE
For pump kit without small plastic snap ring (item
10 in Pump kit content list).
Save the big plastic snap ring and the small
metal clamp from original tube assembly.
tube of the PVC pipe as shown in the picture
below. Push the pipe up to connect both tubes
to the fittings from the ice machine which you
disconnected earlier. Snap and secure the big
snap ring back and tighten on the connection
of the main drain tube. Slide up and secure the
small metal clamp up at the connection.
For pump kit coming with small plastic snap ring
(item 10 in Pump kit content list),
assembly and pick up the small plastic snap ring
from pump package.
to the fittings from the ice machine which you
disconnected earlier. Snap and secure the 2
plastic snap rings, one large and one small, onto
the connections and tighten on the drain tube.
49-1000640 Rev. 4