GE UCC15NPRBII Owner's Manual And Installation Instructions page 21

Drain Pump Kit UPK4 Accessory Installation (Cont.)
DISCONNECT ELECTRICAL
POWER
WARNING
Hazard
follow these instructions.
• Service by a qualified service technician only.
• Reconnect all grounding devices after service.
• Replace all parts and panels before operating.
1
REMOVE ACCESS COVER
the 2 screws from the access panel as shown
in figure below. Slide the panel in the direction
shown to remove.
49-1000640 Rev. 4
Installation Instructions
Electrical Shock
Screws
Access
Panel
Slide panel in
this direction
2
REMOVE DRAIN TUBING
Remove the plastic snap ring from the main
drain tube and release the small metal clamp
on the short drain tube which connected outlet
valve. Pull both tube down. Remove the small
metal clamp from the tube. Keep both snap ring
and clamp for pump kit installation
Snap
Ring
Main
Tube
Remove the white drain pipe by pulling it down
from the 2 locations shown.
3
INSTALL RUBBER PAD TO NEW
PUMP
Remove the rectangular rubber pad from pump
kit and peel off the white sticker. Attach the
sticky side to the drain pump base.
White Sticker
Rubber Pad -
Sticky side up
Outlet
Valve
Small
Metal
Clamp
Short
Tube
21