Power Supply; Remove Packaging; Adjust Height Of Icemaker - GE Monogram ZDIC150 Installation Instructions Manual

Installation Instructions
POWER SUPPLY
WARNING: (Please read carefu,y .
FOR PERSONAL SAFETY, THIS APPLIANCE MUST
BE PROPERLY GROUNDED. Failure to followthese
instructions c an result indeath,fire or electrical
shock.
AVERTISSEMENT :
(S'ilvous lisez avec soin). POUR VOTRE S#CURITI_,
CET APPAREIL DOIT i:TRE CORRECTEMENT MIS #,
LA TERRE. Le non-respect de ces instructions peut
causer la mort, un incendie ou un choc _lectrique.
Do not use on extension cord or adapter plug with
this appliance. Follow National Electrical Code or
prevailing local codes and ordinances.
This icemaker must be supplied with 115V, 60Hz,
and connected to an individual, properly grounded
branch circuit, and protected by a 15 or 20 amp
circuit breaker or time delag fuse.
ElectricalSupplyShould
EnterFromBackWall
In ShadedArea
• A properlg grounded three-prong receptacle should
be located within reach of the icemaker's 66" long
power cord. For a built-in installation, locate the
receptacle in the shaded area shown.
IM PORTANT:
(Please reed carefullg}.
The power cord of this appliance is
equipped with a three-prong ._._
(grounding) plug that mates with a
standard three-prong grounding wall
receptacle to minimize the possibilitg
of electric shock. The customer
should have the wall receptacle and circuit checked
bg a qualified electrician to make sure the receptacle
is properlg grounded and has the correct polaritg.
• Where a standard two-prong wall receptacle is
encountered, it is the personal responsibilitg and
obligation of the customer to have it replaced with
a properlg grounded three-prong wall receptacle.
Do not, under ang circumstances, cut or remove
the third (ground) prong from the power cord.
DO NOT USE AN EXTENSION CORD.
REMOVE PACKAGING AND PARTS
• Lag the carton on rear face
and break open the bottom
flap.
• Set the carton upright
with all four bottom flaps
outward.
Lift carton up and off
icemaker.
/
OpenBottom Flaps
Remove all tape and
packaging material from the outside and inside
of the cabinet.
ADJUST HEIGHT AND
LEVEL THE ICEMAKER
Height adjustments mag be necessarg to install
the icemaker below o countertop, and mag be
accomplished bg adjusting both the front and rear
leveling legs. The icemaker must be level to operate
properlg.
Raise Lower
To level and adjust the height:
• With one person holding the icemaker, carefullg
tilt the machine to access the leveling legs.
Use an adjustable wrench to turn the legs.
-Turn legs right to lower, turn left to raise the
icemaker.
• Check top and side with a level. Continue
adjusting legs until the icemaker is level and
stable.