Saeco SM6685/00 User Manual page 22

22
English
Problem
The machine seems to be
leaking.
I cannot activate the
AquaClean water filter
and the machine asks for
descaling.
The new water filter does
not fit.
The machine is making a
loud noise.
Cause
The milk tubes are clogged.
The machine uses water to rinse
the internal circuit and brew
group. This water flows through
the internal system directly into
the drip tray. This is normal.
The drip tray is too full and has
overflowed which makes it look
like the machine is leaking.
The water tank is not fully
inserted, some water is leaking
out of the water tank and air is
drawn into the machine.
The brew group is dirty/clogged.
The machine is not placed on a
horizontal surface.
The filter has not been installed or
replaced in time after the screen
showed the AquaClean reminder.
This means your machine is not
completely free of limescale
anymore.
You are trying to install another
filter than the AquaClean water
filter.
The rubber ring on the AquaClean
water filter is not in place.
It is normal that your machine
makes some noise during use.
Solution
We advise you to perform the HygieSteam
program every day: 1) Press 'Status' on the
control panel. 2) Select 'HygieSteam'. 3)
Then confirm all steps on the display.
Always store the milk container without
the milk tubes in the refrigerator. Leftover
milk could accumulate inside the milk
tubes and block the flow of milk through
the tubes. Rinse the milk tubes before
storage.
Empty the drip tray every day or as soon as
the 'drip tray full' indicator pops up
through the drip tray cover. Tip: Place a
cup under the dispensing spout to collect
rinsing water and reduce the amount of
water in the drip tray.
Empty the drip tray every day or as soon as
the 'drip tray full' indicator pops up
through the drip tray cover.
Make sure the water tank is in the correct
position: remove it and reinsert it into the
machine as far as possible.
Rinse the brew group.
Place the machine on a horizontal surface
so that the drip tray does not overflow
and the 'drip tray full' indicator works
properly.
Descale your machine first and then install
the AquaClean water filter.
Only the AquaClean water filter fits into
the machine.
Place back the rubber ring on the
AquaClean water filter.
If the machine starts to make a different
kind of noise, clean the brew group and
lubricate it (see 'Lubricating the brew
group').