Table of Contents
Advertisement
Alhambra 1996 ➤ , Alhambra 2001 ➤ , Alhambra 2011 ➤ , Alhambra 2016 ➤ , ...
♦ Transmitter
A - Indicates the device readiness
B - ON-switch
C - Frequency converter
D - Charging port
E - Jack socket for external sensors
F - Ultrasound transmitter
In order to activate the transmitter press switch B.
The ultrasound transmitter makes it possible to send signals
through vehicle interiors, luggage compartments, etc. In doing so,
whistling and other sounds caused by air entering the device can
then be located. The sensitivity setting for the frequency modu‐
lation can be adjusted for thin-walled components.
The green light-emitting diode (LED) indicates that the device is
ready for use. A flashing LED means the device needs to be
charged.
Note
The device switches off on its own after 14 minutes – switch it on
again.
♦ Headphones (ear-enclosing)
These headphones insulate the listener from workshop noise and
increase the efficiency of the device.
Note
It is recommended to always use this headset (which provides
complete covers the ears) as it almost entirely insulates the user
from outside noise.
♦ Unidirectional attachment
The unidirectional attachment is connected to the receiver with a
bayonet coupling and is used to suppress background noise en‐
abling noises to be precisely located. As this is a unidirectional
probe, this effect is amplified.
♦ Pointed attachment
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Manual for locating water entries - Edition 09.2018
6. SEAT equipment for locating water entries
13
Advertisement
Table of Contents
