Table of Contents
Advertisement
en Installation instructions
Use the socket wrench 7 to remove the cooker
4.
burner nozzles.
If your appliance features a wok burner with side ac-
5.
cess, remove the burner nozzle as shown below.
7
Look up the burner nozzles in the table. You can
6.
find additional information about this in the section
entitled "Technical data – Gas" → Page 41.
Fit the new nozzles into the appropriate burners.
‒
After replacing the nozzles, check that there are no
7.
leaks. You can find additional information about this
in the section entitled "Leak and function test"
→ Page 41.
Adjusting or replacing bypass nozzles (small
flame setting)
You can set the minimum flame height for the burners
via the bypass nozzles.
Requirements
¡ Close the gas isolating equipment.
¡ Disconnect the appliance from the power supply.
Switch off all of the knobs on the control panel.
1.
38
7
Remove the knobs one by one by holding them
2.
tightly against the control panel and pulling them to-
wards you slightly.
Converting the appliance from natural gas to
liquefied gas
If the appliance was set to natural gas at the time of
delivery (factory setting) (NG: G20, G25) and is now
being converted to liquefied gas for the first time (LPG:
G30, G31):
In order to gain access to the bypass nozzles, re-
1.
move the control panel. You can find additional in-
formation about this in the section entitled "Remov-
ing the control panel" → Page 38.
Tighten the bypass nozzles as far as it will go.
2.
Then carry out the steps described in the section
3.
entitled "Installing the control panel" → Page 40.
Converting the appliance from liquid gas to
natural gas
If you convert the appliance from liquefied gas
(LPG: G30, G31) to natural gas (NG: G20, G25) or if
you already carried out this conversion and then undo
this:
Replace all of the bypass nozzles in the appliance.
1.
You can find additional information about this in the
section entitled "Removing the control panel"
→ Page 38.
2.
Then carry out the steps in the section entitled "Re-
placing the bypass nozzles" → Page 40.
Then carry out the steps described in the section
3.
entitled "Installing the control panel" → Page 40.
Removing the control panel
If the appliance has an upper cover, remove this.
1.
To do this, open the hob cover, grip the sides
‒
with both hands and pull it upwards. Ensure that
you do not lose the hinges.
Advertisement
Table of Contents
