Table of Contents
Advertisement
en Troubleshooting
Fault
A message with ap-
pears in the display,
e.g.
-
.
There is a smell of
gas in the kitchen.
Burner does not ig-
nite.
Burner goes out
straight after being ig-
nited.
The burner flame is
not uniform.
The burner flame
goes out while the
appliance is in opera-
tion.
20.2 Replacing the oven light bulb
If the light in the cooking compartment fails, change
the oven light bulb.
Note: Heat-resistant, 25-watt, 230 V halogen bulbs are
available from the after-sales service or specialist retail-
ers. Only use these bulbs. Hold the new halogen bulbs
only with a clean, dry towel. This increases the service
life of the bulb.
30
Cause and troubleshooting
Electronics fault
1.
Press
.
If necessary, reset the time on the clock.
‒
a If the fault was a one-off, the error message disappears.
If the error message appears again, call the after-sales service. State the exact error
2.
message and the E no. for your appliance in full.
→ "Customer Service", Page 31
The gas cylinder connection is leaking.
Ventilate the room.
1.
Check the gas cylinder connection.
2.
The gas pipe to the appliance is leaking.
Ventilate the room.
1.
Call the gas supplier.
2.
There has been a power cut.
Light the burner with a gas lighter or a match.
▶
The burner parts are positioned incorrectly.
Position the burner parts precisely and evenly.
1.
Ensure that the locking catches click into place in the recesses.
2.
Burner parts are wet.
Carefully dry the burner parts.
▶
Food remnants or dirt are located between the ignition plug and the burner.
Clean the space between the ignition plugs and burners.
▶
The safety valve for the gas line is closed.
Open the safety valve for the gas line.
▶
Gas cylinder is empty.
Replace the gas cylinder.
▶
There is air in the gas line following initial connection or a cylinder change.
Turn the control knob to 0.
1.
Ignite the burner again.
2.
If necessary, repeat the ignition several times.
3.
The control knob was not held down for long enough.
Keep the control knob pressed in for a few seconds after ignition.
1.
Push the control knob in firmly.
2.
Openings on the burner are soiled.
Clean and dry the openings on the burner.
▶
The burner parts are positioned incorrectly.
Position the burner parts precisely and evenly.
1.
Ensure that the locking catches click into place in the recesses.
2.
Openings on the burner are soiled.
Clean and dry the openings on the burner.
▶
Gas cylinder is empty.
Replace the gas cylinder.
▶
WARNING ‒ Risk of burns!
The appliance and its parts that can be touched be-
come hot during use.
Caution should be exercised here in order to avoid
▶
touching heating elements.
Young children under 8 years of age must be kept
▶
away from the appliance.
Advertisement
Table of Contents
