Voice Function; C-Cdc/R-Cdc/T-Cdc - Midland G18 Instruction Manual

VOICE function

With this function, a voice can be activated to inform of current
operation/selection.
To activate, follow these steps:
1. Press the MENU button;
2. Turn the Encoder knob until "VOICE" is displayed;
3. Push ENT to enter the function;
4. Turn the Encoder knob to activate/deactivate the function:
"ON" (to activate it), or "OFF" (to deactivate it);
5. Confirm your selection with ENT.
C-CDC / R-CDC / T-CDC
The CTCSS tones can be added to the channels for creating new private
channels. They are similar to access codes and enable the radio to
communicate only with the users that are tuned on the same channel
and have set the same code. For each channel you can set up to 50
CTCSS tones and 105 DCS codes.
To select a CTCSS tone:
1. Press the MENU button;
2. Turn the Encoder knob until "C-CDC"(in TX and RX); "R-CDC"(only
in RX) or "T-CDC" (only in TX) appears on the display;
3. Push ENT to enter the function;
4.
Turn the Encoder knob and select the desired CTCSS tone;
5. To confirm, press the ENT button.
The setting of a CTCSS tone disables all DCS codes, because these functions b
cannot be used simultaneously.
To use and select a DCS code, instead of a CTCSS tone, follow these
steps:
1. Press the MENU button;
2. Turn the Encoder knob until: "C-CDC"(in TX and RX); "R-CDC"(only
in RX) or "T-CDC" (only in TX) appears on the display;
i h
3. Push ENT to enter the function;
4. Press the Function key 1;
5.
Turn the Encoder knob and select the desired DCS code;
6. Confirm the selection by pressing the ENT button.
The setting of a DCS code disables all CTCSS tones, because these functions
cannot be used simultaneously.
11 |
12
c d
j
g
f