Troubles He Kiting - Sony MXD-D3 Operating Instructions Manual

Additional Information
"TOC Reading" appears for a long time
II the invriJil recordable MD b* brand nrw, "TOC He-ading'
appears In the display longer than tor MD* that have been
uvd
Limitations when recording over an existing track
• The mrrrrt remaining recording time may not he
displayed,
• You may find n impov.ibk- to record over a track if tlwi
track haw been recorded over iurvcr.il tmu-' already It thr.
happens, crane the track using the Tr F rase Function (aee
pagers ?»i an.i
27)
• The remaining recording lime may be shortened out ot
proportion to the total rtvorded time
• Recording over a track to eliminate noise is not
recommended mmc the. may .horten the duration of the
track.
• You may find it Impossible h* label a track v»hile recording
over It
The correct rccordcd/playmg time may not be displayed
during playback of monaural-format MDs.
Troubleshooting
II you experience any of the following difhcultu*. while
u»ing the deck. usd this troubleshooting guide lo help
you remedy the problem.
CD player section
The player does not start playing.
-♦ Inwrt a CD
-♦ I 'lace t he C D properly
-♦Clean the CD.
-♦ Mobtilrc Condensation has formed inside the deck
fake the < IJ out and leav.' the doi.k tumid on for
about an hour until the moisture evaporates
MD deck section
The deck does not opetate ot operates poorly.
-♦ The Ml) may he damaged ("Disc F/roff" appears!
fake the VIL) out And Insert It again
li • Pine Error!!" remain*, replace the MD
The deck does not play back.
-♦ Moisture has formed inside the deck Take the MDnut
ami leave the deck In u warm place for several hours
until the moisture evaporate*
-* Press l/'J to turn the deck on
-♦Slid.- the MD Into thr disc dot with the tot*! ski. up
and the Arrow ponding towards Ihr opening
-♦ Replace flu- disc with one that has been recorded.
The deck does not record
-♦ The MD is record-protected ("Protected" appi-arv and
"Cl T Hashes)
Close- tlu- record-protect slot (see page 9)
^ Make connection* properly to the wound ■mm*.
-♦ I he sound source m not conned rd to the selected input
connector Select the correct Input connector using
INPUT.
-♦ The recording level
Is
not «dju>tt*d properly Ad|ust
the recording level properly <mv pages
20
and
21
)
-♦ A pmna*lrred MD Is inserted Replace it with a
recordable MD.
There is not enough lime left on the MD Koptaca it
with another recordable MD with fewer molded
(rocks, or rraw unnecessary tracta.
Then* l»as been a power failure or the At' pmver coni
has been disconnected during recording Data
recorded to that point may b«- lost. Repeat the
recording prim-cdurv
The sound has a lot of static.
-♦ strong magnetism Irom a television or a simllat device
is Inlerfri(ng with opcr.itions Move the deck aw.iv
fnim the source of strong magnetism
The three-digit display appears
The Self-Dlagnmu Function I* on
Check the table on page 43
Others
No sound is output.
-* Make tly connection* properly
-♦Operate the amplifier properly
-♦When using (hr headphones. turn
PI
ION
F.
LFVF1 to
turn up the output level
The remote does not operate the deck.
-♦ Make sure that tlirte Is no obstacles In-tween the deck
and the remote
-♦ I'otnt ll»e remote at the remote MMOT on the deck.
«♦ Hcplacc the batteries in the remote
After you've attempted the prescribed
remedies
If the dock still does not operate property, or If other
problems not described above occur, turn off the deck,
then reinsert tlu.* plug into the power outlet
If the problem persists, reset the system as follows:
1 Turn nit the deck and unplug the AC power cord.
2
Reinsert the plug into the power outlet While
pressing down !/(!).
Should any problem persist even after resetting the
system, consult vour nearest Sony dealer.
37