Digital Watchdog MEGApix Ai DWC-XSTD05MF User Manual page 8

Installation -
Disassemble the camera
The mounting surface must withstand five times the camera weight.
1.
Do not let the cables get caught in improper places or the electric line cover can be damaged. This may cause a
2.
short or fire.
Install the Desi-Pack (moisture absorber):
3.
• Remove the Desi-Pack from its shipping packaging.
• Open the camera's control panel on the side of the camera using the star wrench included with the camera.
• Remove the Desi-Pack used for shipping and place the new Desi-Pack in the location shown in the illustration
below.
• Close the camera control panel tightly. When closing the control panel, ensure no cables are caught or
disconnected.
NOTE:
The camera will generate enough heat to dry moisture during operation. In cases where the camera can
experience a moisture issue, keep the moisture absorber in the camera. The moisture absorber has an
approximately 6-month life cycle.
WARNING: Install the moisture absorber when mounting the camera to prevent image performance issues and
damage to the camera.
Mark and drill the necessary holes in the wall or ceiling using the mounting template sheet or the camera itself.
Resetting the camera: Use the tip of a paper clip or a pencil and
press the reset button for five (5) seconds to initiate a camera-wide
reset of all the settings, including network settings.
Warning:
Pressing the 'Reset' button, will initiate a system-wide reset, and you will
lose all settings. Use the export settings tool or take note of the camera
settings as needed.
8