ZyXEL Communications NWA570N Firmware Release Notes page 6

www.zyxel.com
Fix bug 2152 ---- DUT in AP+Repeater mode and disable Intra-BSS Traffic. Wnic and
Bridge mode DUT connect fail
5. [BUG FIXED]
Fix bug 2245 ---- DUT in AP+Repeater mode the throughput of 802.11b/g is about
8M.Throughput of SuperG is equal to 802.11b/g. And 802.11n/g is about 10M
6. [BUG FIXED]
Fix bug 2447 ---- Set 2 DUT to Bridge/AP+Repeater mode, set up connection, after
change DUT's encryption mode again and again,2 DUT can not set up connection
again
7. [BUG FIXED]
Fix bug 2604 ---- The 11n data rate can not change with the status of Short GI.
Example: When the Short GI is enabling, the 11n should be MCS15-130[300], but not
MCS15-130[270].
8. [BUG FIXED]
Remove Super-G option from UI.
9. [BUG FIXED]
Fix the problem that LED will not light in shielding room.
10. [BUG FIXED]
Fix the problem that OTIST LED instead of EZ-Config LED will blink when WPS work.
11. [BUG FIXED]
Change GF Only to HT protect in UI
Modification in V1.00 (AAP.0) B7 |2007/08/01
1. [BUG FIXED]
Fix bug 2404 ---- DUT2(Client mode) connect with DUT1(AP mode),ping each other
successfully, after change SuperG Type, they disconnect, then Client can not try to
connect AP again. But use Broadcom WNIC to connect to DUT1,it is ok
2. [BUG FIXED]
Fix bug 2414 ---- DUT is Client mode, LAN port1 connect to Internet, LAN port2
connect to a PC.DUT connect to an AP(XN2520) with wireless. In DUT's Association
List, there has no AP's signal strength, and PC's signal strength shown "undefined".
3. [BUG FIXED]
Fix bug 2440 ---- DUT connect to PC, set DUT to AP+Repeater mode b/g mode.
Change DUT's SSID/wireless mode/channel, DUT crash and restart.
4. [BUG FIXED]
Fix bug 2445 ---- Default DUT, then enable WPS, the AP's PIN mode will not take
effect until we reboot the DUT or change other WPS mode, then turn back to AP's
ZyXEL Confidential
:
6/13