Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for KitchenAid KHGH 9010/I
Summary of Contents for KitchenAid KHGH 9010/I
- Page 1 5019_719_01010_GB 16-07-2007 10:25 Pagina 1 KHGH 9010/I Instructions for use...
- Page 2 5019_719_01010_GB 16-07-2007 10:25 Pagina 2...
-
Page 3: Table Of Contents
5019_719_01010_GB 16-07-2007 10:25 Pagina 3 Product description and symbols Using the burners Practical advice on using the hob Positioning the pan supports and wok support Hood and cabinetry clearances (mm) Injectors table Safeguarding the environment Installation Gas connection Electrical connection Installation Adaption to a different type of gas supply Replacing the injectors... -
Page 4: Product Description And Symbols
5019_719_01010_GB 16-07-2007 10:25 Pagina 4 Product description and symbols 1. Removable pan supports 2. 1kWh auxiliary burner § 3. 1.65kWh semi- fast burner & 4. 3kWh fast burner 5. 1.65kWh semi- fast burner 6. Professional wok burner 7. Auxiliary burner control knob 8. -
Page 5: Practical Advice On Using The Hob
5019_719_01010_GB 16-07-2007 10:25 Pagina 5 Practical advice on using the hob Read the instructions to get the best out of your one container such as a fish kettle. hob. - Use pans with a similar diameter to the burner Important: (see the table on this page) Do not rest or drag the pan supports upside down - Use flat bottomed pans except with the wok... -
Page 6: Hood And Cabinetry Clearances (Mm)
5019_719_01010_GB 16-07-2007 10:25 Pagina 6 Hood and cabinetry clearances (mm) If a hood is to be installed above the hob, refer to the hood installation instructions to ensure the correct height above the hob Injectors table Category II2H3+ Type of gas used Type of Injector Control primary... - Page 7 5019_719_01010_GB 16-07-2007 10:25 Pagina 7 To get the most out of your hob, please read Note: the instructions carefully and keep them for • Incorrect placement of the pans supports can future consultation. scratch the hob. To avoid this always ensure •...
-
Page 8: Safeguarding The Environment
5019_719_01010_GB 16-07-2007 10:25 Pagina 8 Safeguarding the environment Packing The packing material is 100% recyclable and is Conformity declaration labelled with the recycling symbol . Please This hob was designed, built and marketed in dispose of all packing responsibly and carefully. compliance with: •... -
Page 9: Installation
100cm • This hob is designed to operate perfectly with section, which must be: any oven in the KitchenAid range. The - perminent and accessable on the walls of the Manufacturer declines all responsibility should room being ventilated and extracting towards any other make of oven be installed. -
Page 10: Electrical Connection
5019_719_01010_GB 16-07-2007 10:25 Pagina 10 Electrical connection The electrical connections must comply with current legislation and be carried out by a qualified, competent person. • Information on the voltage and power absorbed are shown on the serial no. plate. Earth •... -
Page 11: Adaption To A Different Type Of Gas Supply
5019_719_01010_GB 16-07-2007 10:25 Pagina 11 Adaption to a different type of gas supply If you are using a different kind of gas from the one requested from the Customer Care Centre on indicated on the serial no. plate and the orange 00800-3810-4026. -
Page 12: Fitting The Wok Burner
5019_719_01010_GB 16-07-2007 10:25 Pagina 12 Fitting the wok burner To fit the double crown wok burner: Insert in the following order: 1. burner ring (A); 2. decorative covering ring (B); 3. external burner cap (C); 4. internal burner cap (D). Note: make sure that: 1. -
Page 13: General Cleaning And Maintenance
5019_719_01010_GB 16-07-2007 10:25 Pagina 13 General cleaning & maintenance Always disconnect the hob from the electrical quickly as possible (sauce, coffee, etc..). Wash power supply and wait until it cools before with luke warm water and a mild detergent, cleaning and/or doing maintenance work. rinse and dry carefully with a soft cloth, or a In order to keep your hob in good condition, you cloth designed to clean stainless steel. -
Page 14: Troubleshooting Guide
5019_719_01010_GB 16-07-2007 10:25 Pagina 14 Troubleshooting guide If the hob is not working properly work through 2. the burner’s openings are not blocked in the this guide before contacting our Customer relation to the thermocouple. Care Centre. 3. the end part of the thermocouple is clean. The burner does not ignite, or the flame is The pans are not stable? Check that: unsteady? Check that:... - Page 15 5019_719_01010_GB 16-07-2007 10:25 Pagina 15...
- Page 16 5019_719_01010_GB 16-07-2007 10:25 Pagina 16 Whirlpool Europe S.r.l. Viale G. Borghi, 27 - 21025 Comerio (VA) Phone 0332.759111 - Fax 0332.759268 www.whirlpool.eu Printed in Italy 07/07 5019 719 01010...
Need help?
Do you have a question about the KHGH 9010/I and is the answer not in the manual?
Questions and answers