Hose Kit Installation Instructions - OCEANAIRE OWC QC Series Engineering, Installation And Service Manual

HK-QC Series Hose Kits
INSTALLATION INSTRUCTIONS
1. Connect Hose Kit to unit by aligning the QC Coupling with the QC Fitting
on the unit. Connect the hose kit according to hose and unit labels:
BLACK to WATER IN, RED to WATER OUT and YELLOW to DRAIN. HOLD
the coupling behind the sleeve allowing the sleeve to move freely and
PRESS firmly, until the sleeve retracts and clicks. The "click" means that
the QC Coupling is engaged onto the QC Fitting.
2. Connect WATER IN hose to water supply using hose connection, and
sink adapter (if needed).
3. Install WATER OUT line in drain, allowing for free drain conditions
with an air space around the opening.
4. Install DRAIN line in drain, allowing for free drain conditions.
5. Open water supply valve, and check for any water leaks in hose
connections.
To release the coupling, Hold the Coupling as shown below, and pull back
on the sleeve. The Coupling will release and the valve inside of the
coupling will seal. Once off-site, use the fitting secured to the hose kit by
the lanyard to release the valve and drain the hoses.
14