Installation Instructions/Start Up Procedure; Accessories - OCEANAIRE OWC QC Series Engineering, Installation And Service Manual

INSTALLATION INSTRUCTIONS
RECEIVING—INSPECTION
Upon receiving your unit, inspect the packaging for any damage. All units
are shipped on a skid, and packaged in a triple-wall carton for added
protection.
BEFORE INSTALLING
Check the unit for any damage. All Oceanaire products are thoroughly
inspected at the factory and carefully packaged. If any damage is evident,
contact Oceanaire
IMMEDIATELY.
START-UP
Install the unit in accordance with all local and state building codes, and
install all accessories. Allow for a clearance around the unit for future
maintenance and/or service. Level unit and lock casters. Connect power
cord. Power up unit via thermostat, and check for proper operation. Refer to
Thermostat Operation for more details
.
ELECTRICAL REQUIREMENTS
Check the nameplate located on the back of the unit to confirm the proper
power is available for the unit. Refer to "Specifications" section for voltage
and amperage requirements. For the proper NEMA receptacle, refer to
"Electrical service plug configuration". When using an extension cord, use
the proper gauge cord, and check cord voltage at the unit.
TIME DELAY FUSES/CIRCUIT BREAKERS ARE RECOMMENDED
WARNING—OPERATING THE UNIT ON IMPROPER VOLTAGE
WILL VOID THE WARRANTY

ACCESSORIES

Verify that all accessories are correct for the model, and are installed in
accordance with all instructions.
8