Table of Contents
Advertisement
Configuration Information
Introduction
A
This appendix describes how to configure MPE to include the ThinLAN 3000/V
link.
The MPE configuration must be modified when a LANIC card is added to the
computer system. Before configuring MPE, install the LANIC card as described
in Chapter 2.
Configuration Dialog
The following configuration dialog deals only with configuring a LA NIC card
into the system. The complete configuration dialog is contained in the H P 3000
System Operation and Resource Management Relerence Manual.
part number
32033-90005.
To begin the configuration dialog. log onto the system as MANAGER.syS,
define the output files as shown below, and initiate a SYSDUMP as outlined in
the following steps.
NOTE
Where necessary to distinguish user input from computer output. the user input
is underlined. The "Step No." in the dialog below corresponds to the "Step
Number" in the dialog contained in the H P 3000 System Operation and Resource
."4 anagement Rc:/erence
A1 anual. part number 32033-90005.
It is essential that the LANIC driver. IOLANO.PURSYS be present when the
UPDATE or COLDSTART or RELOAD is done. You may verify that the driver
is present by typing:
:LISTF IOLANO.PUB.SYS
Define the output files and initiate SYSDUMP as follows:
:HELLO MANAGER.SYS
:FILE T;DEV=TAPE
:FILE L;DEV=LP
:SYSDUMP *T,*L
Configuration Information
A-I
Advertisement
Table of Contents
