Cuckoo CRP-PK06 Series Operating Instructions Manual page 10

HOW TO CLEAN
How to clean the Soft Steam Cap
※ Do not touch the Soft Steam after cooking. It can cause scalding or burns.
As the picture shows, hold the ridge
of the steam cap and turn it to the left
side.
Lift it up gently for detachment.
How to use Lock/Unlock Handle
1. Make sure to close the lid and turn the Lock/Unlock Handle to "Locked."
" " will be displayed. This is the function of safety device which indicates
that the appliance is properly locked and ready for cooking.
2. When cooking is done, turn the Lock/Unlock Handle from "Unlocked" to
"Locked," and then open the lid by pressing the Clamp Knob.
If steam is not completely exhausted after cooking, the handle might not
be able to be easily turned from 'Locked' to "Unlocked". In such a case,
allow remaining steam to escape by tilting the Pressure Weight. Do not
attempt to turn the Lock/Unlock Handle by force.
3. When opening or closing the lid of the appliance, make sure that the
Lock/Unlock handle is completely turned to "Unlocked".
How to clean the Soft Steam Cap
Do not close the lid by force. It can cause malfunctions. Read and follow the following instructions.
10
1. Check if the Inner Pot is in the
right position. (Make sure to
the handles of Inner Pot is
matched to the grooves on the
inner body.)
2. Make sure that the Lock/Unlock
Handle is turned as shown in
the picture on the right.
Please use the dish detergent and
sponge to clean the inner side of
the steam cap often.
• If the "Lock" is not illuminated
after turning the Lock/Unlock
Handle to 'Locked', attempt to
turn the Lock/Unlock Handle to
'Locked' in a correct way.
• The correct position of the locked
Lock/Unlock Handle is as shown
in the picture on the right.
3. The lid might not be closed well if
When reassemble the steam cap,
place the ① at the position that
shows in the picture and firmly
attach the ② part
LOCK
steam has not completely escaped or
steamy food or hot water is in the
appliance. In such a case, close the
lid after tilting the Pressure Weight,
and then fasten the Lock/Unlock
Handle by turning it clockwise.