Rear Panel Features - AudioControl Director M6800D Installation Manual

Rear Panel Features

2 3
1
AC section
When rack-mounting the unit,
make sure that the power cord
and the AC power switch remain
readily accessible.
1. AC Input
Connect the supplied AC power cord
securely to this input. Plug the other
end into an AC mains outlet of the
correct voltage rating for your unit.
They are either 100 -120 VAC (50 – 60
Hz) or 220 – 240 VAC (50 – 60 Hz).
A checked box designates the unit
configuration and it is not user-
settable.
2. AC Fuse
The main power supply fuse may
be checked or replaced. Before
attempting to undo the fuse carrier
from the holder, remove the power
cord from the AC mains. The carrier
may be backed out of the holder by
carefully placing the tip of a flat-head
screwdriver into the slot on the carrier,
and slowly turning anti-clockwise.
16
5 6 7
Number
D
Address
Disable front panel
Master
LED ladders
Reset
4
8
10
Serial
MAC
11
9
Inspect the fuse for failure, and if
required, replace it with the exact
same type indicated on the unit. The
use of a fuse with a different amperage
or voltage rating may lead to an
unsafe condition. Upon replacement, if
the new fuse subsequently fails when
power is applied to the unit, move the
power cord and contact AudioControl
customer service. Do not open up
the unit – there are no Internal user-
serviceable parts, and dangerous
voltages remain present for a duration
after the AC mains power has been
removed.
3. AC Power Switch
This switch shuts off the main AC
power. This may only be required to
be turned off when the system will be
shut down for an extended period of
time. Operational Ethernet commands
or the master trigger inputs are
used for switching the unit between
standby and on.
Rear Panel
12 13
14