English (Original instructions) power source and/or battery pack, picking up or GENERAL POWER TOOL SAFETY carrying the tool. WARNINGS Carrying power tools with your nger on the switch or energising power tools that have the switch on WARNING invites accidents. Read all safety warnings and all instructions.
English c) When battery pack is not in use, keep it away eye is a threat to sight. Eye protection can be bought at from other metal objects, like paper clips, coins, any hardware store. Always wear eye protection while keys, nails, screws or other small metal objects, operating this tool.
English 15. Beware of the tool’s kickback. 24. Do not use the charger continuously. Do not approach the top of the tool with your head etc. When one charging is completed, leave the charger for during operation. This is dangerous because the tool about 15 minutes before the next charging of battery.
English ○ Do not store an unused battery in a location exposed to REGARDING LITHIUMION BATTERY swarf and dust. TRANSPORTATION ○ Before storing a battery, remove any swarf and dust that may adhere to it and do not store it together with metal When transporting a lithium-ion battery, please observe the parts (screws, nails, etc.).
The battery remaining power is nearly empty. Weight Recharge the battery as soon as possible. (According to EPTA-Procedure 01/2003) Battery indicator:1 LED (Red) blink Contact HiKOKI for inspection. Switching ON Battery indicator: 2 LEDs blink in Orange, after 10 seconds, automatically turn off Switching OFF Power switch.
Weight 0.5 kg NOTE Due to HiKOKI’s continuing program of research and development, the speci cations herein are subject to change without prior notice. NAIL SELECTION Choose a suitable nail from Fig. Nails which are not shown in Fig. can not be driven with this tool.
English NR1890DBRL Plastic-collated strip nails Min. Max. Full-head nails 7 mm 7.6 mm 2.9 mm 3.3 mm * This Nailer is not recommended for use with from 75 mm to 90 mm ring shank nails in pressured-treated lumber. STANDARD ACCESSORIES CHARGING In addition to the main unit (1 unit), the package contains the Before using the power tool, charge the battery as follows.
30 seconds or so. If this does not cause the capacity, approx. (At 20C) pilot lamp to blink in red (every second), please take the charger to the HiKOKI Authorized Service Center. 1.3 Ah min. 1.5 Ah min.
Page 17
Conduct the tests in the following power is about half. order. If abnormal operation occurs, stop using the Nailer and contact a HiKOKI authorized service center immediately. 1 LED (Red) lights (1) REMOVE ALL NAILS AND BATTERY FROM NAILER. The battery remaining □...
Page 18
1) loading nails; When loading nails into Nailer, 2) turning the adjuster. 1) remove battery from the nailer; This HiKOKI nailer is equipped with a nailer operation 2) do not pull trigger; switching device. 3) do not depress push lever; and Use FULL SEQUENTIAL ACTUATION MECHANISM or 4) keep nailer pointed downward.
Page 19
There are two methods of operation to drive nails with ○ Keep hands and body away from the discharge area. this Nailer. This HiKOKI nailer may bounce from the recoil of driving They are: a nail and unwanted subsequent nail may be driven, 1.
M5 bolt. Important notice on the batteries for the HiKOKI NOTE cordless power tools In case of frequent jam, contact a HiKOKI authorized Please always use one of our designated genuine service center. batteries. We cannot guarantee the safety and 5.
Page 21
NOTE Due to HiKOKI’s continuing program of research and development, the speci cations herein are subject to change without prior notice.
Nailer operation. TROUBLESHOOTING Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your dealer or the HiKOKI Authorized Service Center. PROBLEM CHECK METHOD CORRECTION Power switch doesn’t turn on.
Need help?
Do you have a question about the NR 1890DBRL and is the answer not in the manual?
Questions and answers