Related Manuals for HIKOKI NT 1865DMB
Summary of Contents for HIKOKI NT 1865DMB
- Page 1 NT 1865DMA NT 1865DM NT 1865DMB NT 1850DE • • • NT 1865DMA NT 1865DM NT 1865DMB NT 1850DE Handling instructions...
- Page 2 <NT1865DMA> <NT1865DM> <NT1865DMB> <NT1850DE>...
- Page 3 < > UC18YFSL...
- Page 4 < > NT1865DMA / NT1865DM / NT1865DMB < > < > NT1865DMA / NT1865DM / NT1865DMB NT1865DMA / NT1865DM / NT1865DMB < > < > NT1865DMA / NT1865DM / NT1865DMB NT1865DMA / NT1865DM / NT1865DMB...
- Page 5 < > < > NT1850DE NT1850DE < > NT1850DE...
- Page 6 < > NT1865DM < > NT1865DMA < > NT1865DMB...
- Page 7 < > NT1850DE...
-
Page 8: General Power Tool Safety Warnings
power source and/or battery pack, picking up or GENERAL POWER TOOL SAFETY carrying the tool. WARNINGS Carrying power tools with your fi nger on the switch or energising power tools that have the switch on WARNING invites accidents. Read all safety warnings and all instructions. d) Remove any adjusting key or wrench before Failure to follow the warnings and instructions may result in turning the power tool on. -
Page 9: Additional Safety Warnings
c) When battery pack is not in use, keep it away eye is a threat to sight. Eye protection can be bought at from other metal objects, like paper clips, coins, any hardware store. Always wear eye protection while keys, nails, screws or other small metal objects, operating this tool. - Page 10 15. Beware of the tool’s kickback. 24. Always charge battery ambient Do not approach the top of the tool with your head etc. temperature of 0–40°C. during operation. This is dangerous because the tool A temperature of less than 0°C will result in over charging may recoil violently if the nail currently being driven in which is dangerous.
-
Page 11: Caution On Lithium-Ion Battery
3. If you fi nd rust, foul odor, overheating, discolor, CAUTION ON LITHIUM-ION BATTERY deformation, and/or other irregularities when using the battery for the fi rst time, do not use and return it to your To extend the lifetime, the lithium-ion battery equips with the supplier or vendor. - Page 12 Trigger unlocked NT 1865DMA : Cordless Finish Nailer NT 1865DM : Cordless Finish Nailer Battery indicator switch NT 1865DMB : Cordless Finish Nailer NT 1850DE : Cordless Brad Nailer The battery remaining power is enough Battery indicator: 2 LEDs (Red) light The battery remaining power is about half.
-
Page 13: Specifications
Battery Deep side Lights ; The battery remaining power is over 75% Warning Lights ; The battery remaining power is 50%–75%. Lights ; Prohibited action The battery remaining power is 25%–50%. Lights ; The battery remaining power is less than 25% Blinks ;... - Page 14 Depending on attached battery. The heaviest weight is measured with BSL36B18 (sold separately). 3. Battery Charger Model UC18YFSL Charging voltage DC 14.4–18 V Weight 0.5 kg NOTE Due to HiKOKI’s continuing program of research and development, the specifi cations herein are subject to change without prior notice.
-
Page 15: Nail Selection
NAIL SELECTION Only nails shown in the Table below can be driven with this Nailer. Dimensions of nails <NT1865DMA> Min. Max. 2.4 mm 15 Gauge fi nish nails (Angle: 34°) 34° 1.8 mm <NT1865DM> Min. Max. 2.8 mm 16 Gauge fi nish nails (straight) 1.4 mm 1.65 mm... -
Page 16: Standard Accessories
<NT1865DMB> Min. Max. 2.8 mm 16 Gauge fi nish nails (Angle: 20°) 20° 1.4 mm 1.65 mm <NT1850DE> Max. 18 Gauge brad nails 1.9 mm (straight) 1 mm 1.25 mm STANDARD ACCESSORIES APPLICATIONS In addition to the main unit (1 unit), the package contains the <NT1865DMA, NT1865DM, NT1865DMB>... - Page 17 3. Charging CHARGING When inserting a battery in the charger, charging will commence and the pilot lamp will light up continuously Before using the power tool, charge the battery as follows. in red. 1. Connect the charger’s power cord to the receptacle. When the battery becomes fully recharged, the pilot lamp (Fig.
-
Page 18: Before Use
30 seconds or so. If this does not cause the pilot lamp to blink in red (every second), please take the NOTE charger to the HiKOKI Authorized Service Center. There are situations in which this product will not operate when two LEDs are lit on the battery’s remaining battery BEFORE USE indicator. - Page 19 If abnormal operation occurs, stop using the Nailer and Depress the push lever against the workpiece within contact a HiKOKI authorized service center immediately. 2 seconds. (1) REMOVE ALL NAILS AND BATTERY FROM NAILER. □ THE NAILER MUST NOT OPERATE.
- Page 20 The nails shown in page 16 can be loaded onto the side 2) turning the adjuster. guide groove of the magazine without any adjustment. This HiKOKI nailer is equipped with a nailer operation Always keep the points of nails in contact with Groove. switching device.
- Page 21 ○ Keep hands and body away from the discharge area. 1. Intermittent operation (Trigger fi re): This HiKOKI nailer may bounce from the recoil of driving 2. Continuous operation (Push lever fi re): a nail and unwanted subsequent nail may be driven, (1) Intermittent operation (Trigger fi...
-
Page 22: Maintenance And Inspection
Please always use one of our designated genuine NOTE batteries. We cannot guarantee the safety and In case of frequent jam, contact a HiKOKI authorized performance of our cordless power tool when used with service center. batteries other than these designated by us, or when the battery is disassembled and modifi... - Page 23 Depending on the conditions at the workplace and the form NOTE of the workpiece, individual noise attenuation measures Due to HiKOKI’s continuing program of research and may need to be carried out, such as placing workpieces on development, the specifi cations herein are subject to sound-damping supports, preventing workpiece vibration by change without prior notice.
-
Page 24: Troubleshooting
TROUBLESHOOTING Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your dealer or the HiKOKI Authorized Service Center. PROBLEM CHECK METHOD CORRECTION Power switch doesn’t turn Low battery charge. - Page 25 NT1865DMA NT1865DM NT1865DMB NT1850DE (NN) (NN) (NNP) (NN) (NNP) (NN) ― ― ― ― ― ― BSL1830C BSL1820M ― ― ― ― ― ― UC18YFSL ― ― ― ― ― ― ― ― ― ― ― ― ― ― ― ―...
- Page 26 BSL36..18 BSL18.. UC18YFSL (14.4 V–18 V) 329897 337528...
- Page 29 English Português GUARANTEE CERTIFICATE CERTIFICADO DE GARANTIA Model No. Número do modelo Serial No. Número do série Date of Purchase Data de compra Customer Name and Address Nome e morada do cliente Dealer Name and Address Nome e morada do distribuidor (Please stamp dealer name and address) (Por favor, carímbe o nome e morada do distribuidor) Deutsch...
- Page 31 Hikoki Power Tools Deutschland GmbH Hikoki Power Tools Norway AS Siemensring 34, 47877 willich, Germany Kjeller Vest 7, N-2007 Kjeller, Norway Tel: +49 2154 49930 Tel: (+47) 6692 6600 Fax: +49 2154 499350 Fax: (+47) 6692 6650 URL: http://www.hikoki-powertools.de URL: http://www.hikoki-powertools.no Hikoki Power Tools Netherlands B.V.
- Page 32 EN60745-2-16:2010 EN60335-1:2012+A11:2014 EN60335-2-29:2004+A2:2010 EN55014-1:2006+A1:2009+A2:2011 EN55014-2:1997+A1:2001+A2:2008 Importer and authorized person to compile the technical fi le Hikoki Power Tools (U.K.) Ltd. 25 Majestic Road, Southampton, SO16 OYT, United Kingdom 30. 9. 2022 Head offi ce in Japan Koki Holdings Co., Ltd.
Need help?
Do you have a question about the NT 1865DMB and is the answer not in the manual?
Questions and answers